Cisco Systems AIRCAP702IAK9 Configuring Dhcp Option 43 and Dhcp Option, Access Point Models

Page 23

Operation of Cisco Aironet Access Points in Brazil

This section contains special information for operation of Cisco Aironet access points in Brazil.

Access Point Models

AIR-CAP702I-T-K9

AIR-SAP702I-T-K9

Portuguese Translation

Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência prejudicial, mesmo de estações do mesmo tipo, e não pode causar interferência a sistemas operando em caráter primário.

English Translation

This equipment operates on a secondary basis and consequently must accept harmful interference, including interference from stations of the same kind. This equipment may not cause harmful interference to systems operating on a primary basis.

Declaration of Conformity Statements

All the Declaration of Conformity statements related to this product can be found at the following location: http://www.ciscofax.com

12Configuring DHCP Option 43 and DHCP Option 60

This section contains a DHCP Option 43 configuration example on a Windows 2003 Enterprise DHCP server for use with Cisco Aironet lightweight access points. For other DHCP server implementations, consult product documentation for configuring DHCP Option 43. In Option 43, you should use the IP address of the controller management interface.

Note DHCP Option 43 is limited to one access point type per DHCP pool. You must configure a separate DHCP pool for each access point type.

The 700 series access point uses the type-length-value (TLV) format for DHCP Option 43. DHCP servers must be programmed to return the option based on the access point’s DHCP Vendor Class Identifier (VCI) string (DHCP Option 60). The VCI string for the 700 series access point is:

Cisco AP c700

Note If your access point was ordered with the Service Provider Option (AIR-OPT60-DHCP) selected in the ordering tool, the VCI string for the access point contains ServiceProvider. For example, a 700 with this option will return this VCI string:

Cisco AP c700-ServiceProvider

The format of the TLV block is listed below:

•Type: 0xf1 (decimal 241)

•Length: Number of controller IP addresses * 4

•Value: List of WLC management interfaces

To configure DHCP Option 43 in the embedded Cisco IOS DHCP server, follow these steps:

Step 1 Enter configuration mode at the Cisco IOS CLI.

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Cisco Aironet 700 Series Access Points About this Guide Introduction to the Access PointSafety Instructions 20A. Statement Unpacking ConfigurationsAccess Point Ports and Connectors Access Point LED Indicator top Access Point Ports and Connections bottom Configuring the Access PointController Discovery Process Pre-Installation Configuration Setup Preparing the Access PointInstallation Summary Performing a Pre-Installation ConfigurationController Layer 3 devices Cisco Aironet access points Deploying the Access Point on the Wireless Network Mounting the Access PointChecking the Access Point LED TroubleshootingUsing Dhcp Option Troubleshooting the Access Point Join Process Models Declarations of Conformity and Regulatory InformationUSA Vcci Statement for JapanEnglish Translation Statement 371-Power Cable and AC AdapterJapanese Translation French Translation Industry Canada Canadian Compliance StatementModels Declaration of Conformity for RF Exposure This Device Meets FCC Guidelines for Exposure to Radio Waves Generic Discussion on RF ExposureAdditional Information on RF Exposure Chinese Translation English Translation Chinese Translation English Translation Declaration of Conformity Statements Configuring Dhcp Option 43 and Dhcp OptionOperation of Cisco Aironet Access Points in Brazil Access Point ModelsAdd the option 60 line using the following syntax Access Point SpecificationsObtaining Documentation and Submitting a Service Request
Top Page Image Contents