Figure 20. This is the oscillation
timing control knob.
5.When you get the belt to oscillate without stopping, experiment with the timing knob to see the effect its movement has on the belt oscillation.
6.Position the timing knob so the belt moves from one side to the other, back and forth, in even intervals.
7.Lock the knob in place by turning it clock- wise.
Long term exposure to this machine during operation may cause
hearing loss. Wear approved hearing pro- tection to minimize this risk!
Oscillation Speed
Use the valve shown in Figure 21 to control the speed of the sanding belt oscillation. Make sure the oscillation is balanced before adjusting the speed.
Figure 21. Use the knob on this valve to control
oscillation speed.
Keep loose clothing out of the way of moving machinery and keep long hair pulled back.
To increase the oscillation speed, open the valve (turn the knob
To decrease the oscillation speed, close the valve (turn the knob clockwise). When the speed is correct, tighten the jamnut.
Different speeds may yield different finishing results. Experiment with
|
|
|
|
|
|
|
|
|
|
|
|
G9983 15" | |||