SECTION 2: CIRCUIT REQUIREMENTS
110V Operation
Serious personal injury could occur if you connect the machine to the power source before you have completed the set up pro- cess. DO NOT connect the machine to the power source until instructed to do so.
Amperage Draw
The Model H7760 motor draws the following amps under maximum load:
Motor Draw | 3.2 Amps |
Circuit Recommendations
We recommend connecting this machine to a dedicated circuit with a verified ground (Figure 3), using the circuit breaker size given below. Never replace a circuit breaker with one of higher amperage without consulting a qualified electri- cian. If you are unsure about the wiring codes in your area or you plan to connect your machine to a shared circuit, you may create a fire
Circuit Breaker....................................... 10 Amps
Plug/Receptacle Type
Included Plug Type | NEMA |
Electrocution or fire could result if this machine is not grounded correctly or if your electrical configu- ration does not comply with local and state codes. Ensure compliance by checking with a qualified electrician!
H7760 2" x 27" Belt Sander & 6" Grinder
Figure 3. Typical type 5-15 plug & receptacle.
This machine must have a ground prong in the plug to help ensure that it is grounded. DO NOT remove ground prong from plug to fit into a
Extension Cords
We do not recommend the use of extension cords. If you find it absolutely necessary:
•Use at least a 16 gauge cord that does not exceed 50 feet in length!
•The extension cord must also contain a ground wire and plug pin.
•A qualified electrician MUST size cords over 50 feet long to prevent motor damage.