Grizzly H7760 Items Needed for Set Up, Mounting, Description Qty, To mount the grinder

Page 13

Items Needed for

Set Up

The following items are needed to complete the set up process, but are not included with your machine:

Description

Qty

Wrench 8mm

1

Wrench 13mm

1

Hex Bolt M8-1.25 (length varies)

2

Flat Washer 8mm

4

Lock Washer 8mm

2

Hex Nut M8-1.25

2

Mounting

The Model H7760 weighs 22 lbs. Make sure the workbench on which you plan to mount the grinder is sturdy enough to hold the weight of the machine and any downward pressure that may be applied during operation. The workbench should have a level surface and be heavy, or attached to the floor so that it will not move during operation.

Components and Hardware Required

Qty

Sander/Grinder Unit

1

Hex Bolt M8-1.25 (length varies)

2

Flat Washer 8mm

4

Lock Washer 8mm

2

Hex Nut M8-1.25

2

The Model H7760 can cause personal injury if operated by untrained users. Ensure that your machine is inac- cessible to children and visi- tors by closing and locking all entrances to your shop/ garage when you are away.

NOTICE

When mounted, the cooling tray can be eas- ily damaged if the grinder is tipped forward.

H7760 2" x 27" Belt Sander & 6" Grinder

To mount the grinder:

1.Find the best place in your shop to mount the grinder/sander.

—Pick a spot on the workbench that will allow enough room to move the size of an anticipated workpiece around the grinder. The operator (and possibly bystanders) should have enough room to stand out of the way.

—Mount the grinder in an area with proper lighting and near electrical out- lets. Lighting should be bright enough to eliminate shadow and prevent eye strain. Electrical circuits should be dedicated or large enough to handle amperage requirements.

Note: Keep power or extension cords clear of high-traffic areas. If you install new light- ing, outlets, or circuits, observe all electrical codes.

2.Mount the grinder to the workbench with bolts that are long enough to exceed the thickness of your workbench and the grinder base. Secure each bolt with flat washers, a lock washer, and a hex nut as illustrated in Figure 5.

Note: Because sizes vary for each individual situation, the hardware in this step is not included with the Model H7760.

H7760

 

Base

Bolt

 

 

Flat

 

Washer

 

Flat

 

Washer

Workbench

Lock

 

 

Washer

 

Nut

Figure 5. Mounting machine to the workbench.

-11-

Image 13
Contents Model H7760 Page Table of Contents Foreword IntroductionContact Info Features Overall DimensionsMotor H7760 front view IdentificationSafety Instructions for Machinery SafetyAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Grinders Additional Safety Instructions for Sanders 110V Operation Circuit RequirementsUnpacking SET UPInventory Inventory QtyMounting Items Needed for Set UpDescription Qty Components and Hardware Required QtyTo install the spark guard and eye shield To install the tool restsTool Rests Spark Guard Eye ShieldDust Port Belt TrackingTo track the sanding belt To connect the dust port to a dust collection systemTest Run OperationOperating Grinder Before GrindingTo properly care for your wheel, follow these tips Wheel CareTo dress the grinding wheel Prefix Abrasive Grit Grade Bond Type Type Wheel Selection Wheel InspectionTo perform a Ring Test Wheel mounting order Replacing WheelsSanding a workpiece SandingTo remove/replace a sanding belt Replacing BeltsAccessories General MaintenanceLubrication Grinding WheelsTroubleshooting ServiceParts Breakdown Description Parts ListWarranty and Returns Page Page