Grizzly G1531 manual Working Table, Horizontal/Vertical brace installed
Page 11
Working Table
1.Bolt the lead screw bracket to the front of the stand using the four Hex Bolts already threaded in place. Figure 4.
Figure 4. Lead screw bracket Installed.
2.Thread the horizontal brace into position, but do not tighten it down; the brace will require further adjustment later on. Figure 5.
Figure 5. Installing the horizontal brace.
G1531 Edge Sander
3.Locate the lead screw / table bracket assem- bly and the handwheel. Thread the hand- wheel onto the lead screw about halfway and insert the lead screw into the lead screw bracket. Figure 6.
Figure 6. Installing the lead screw assembly.
4.Locate the vertical brace and remove the top Hex Nut and Flat Washer.
5.Turn the horizontal brace approximately 45˚ and insert the vertical brace through the hole at the end of the horizontal brace. Rotate the horizontal/vertical brace assembly to 90˚.
6.Insert the threaded end of the vertical brace through the hole in the bottom of the table bracket and re-install the Flat Washer and Hex Nut back onto the shaft. Figure 7.
