Grizzly G1531 manual Edge & End Sanding, Contour Sanding

Page 20

Edge & End Sanding

Figure 23 depicts a typical edge sanding process.

Figure 23. Edge sanding process.

Figure 24 depicts a typical method for sanding the end of a workpiece.

Figure 24. Sanding the end of a piece.

Contour Sanding

When contour sanding, adjust the auxiliary table up or down so the workpiece is roughly centered on the roller. Move the workpiece over the roller to achieve your desired profile. Figure 25.

Figure 25. Contour sanding on auxiliary table.

 

 

 

 

 

 

 

 

-18-

 

 

G1531 Edge Sander

 

 

Image 20
Contents Edge Sander Page Table Of Contents Introduction Safety Rules for ALL Tools Safety Instructions For Power Tools16 A.W.G 50ft Unpacking Piece Inventory Overview of all the parts G1531 Edge SanderClean up Site Considerations Circuit Requirements Recommended 220V plug/receptacleAssembly Beginning Assembly FeetHorizontal/Vertical brace installed Working TableSetting the pointer to 90˚ G1531 Edge Sander Miter Body Quick Release Lever Attaching the miter bodyAuxiliary Table Dust Hood Dust hood mounted in place G1531 Edge SanderBelt Installation Belt installedAdjustments Belt Tracking Auxiliary TableTable Height Table TiltBelt Tension Edge Sander Safety Rules OperationsTest Run Edge & End Sanding Contour SandingLubrication MaintenanceGeneralTable Closure Machine Data Sheet REF# 47A Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC