Grizzly G1531 manual Adjustments, Belt Tracking Auxiliary Table

Page 16

SECTION 3: ADJUSTMENTS

Belt Tracking		Auxiliary Table

1.Carefully move the belt left to right by hand and adjust the tracking knob as necessary to achieve proper tracking. Figure 18.

2.Before beginning this step, read the Safety Rules on page 17 and Test Run on page 18. Connect to power and turn the machine on and off quickly. If the belt appears to track OK turn the machine on and fine tune the tracking. Tighten the tracking lock knob.

Adjustment Knob

Locking Knob

Figure 18. Belt tracking adjustment knobs.

Loosen the thumb screws, position the auxiliary table, re-tighten the thumb screws. Figure 19. Note that the ends of the roller are tapered. This helps keep the belt tracked. When using the end roller for curved sanding, we recommend you use the center portion of the roller to assure proper belt tracking. This also prevents the edge of the workpiece from becoming tapered.

Figure 19. Auxiliary table positioning.



-14-			G1531 Edge Sander
-14-			G1531 Edge Sander

Image 16

Contents Edge Sander Page Table Of Contents Introduction Safety Rules for ALL Tools Safety Instructions For Power Tools16 A.W.G 50ft Unpacking Piece Inventory Overview of all the parts G1531 Edge SanderClean up Site Considerations Circuit Requirements Recommended 220V plug/receptacleAssembly Beginning Assembly FeetHorizontal/Vertical brace installed Working TableSetting the pointer to 90˚ G1531 Edge Sander Miter Body Quick Release Lever Attaching the miter bodyAuxiliary Table Dust Hood Dust hood mounted in place G1531 Edge SanderBelt Installation Belt installedAdjustments Belt Tracking Auxiliary TableBelt Tension Table TiltTable Height Edge Sander Safety Rules OperationsTest Run Edge & End Sanding Contour SandingGeneralTable MaintenanceLubrication Closure Machine Data Sheet REF# 47A Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC