Miter Body | Quick Release Lever | |
|
|
|
|
|
|
Set the miter body onto its pivot hole and secure into place with the plastic lock knob provided.
Figure 12.
The miter body should only be used when sanding the ends of workpieces at least 8 ' long. Do not use it as a back stop.
1.Loosen the belt tracking lock knob located at the top left of the machine.
2.Slide the quick release lever through the slot on the top of the platen cover. Thread it into place until it bottoms out. Figure 13. It may be necessary to have an assistant push the idler roller back into the machine to allow the quick release lever to line up with the thread in the yoke.
Care must be taken so that the machine is not tipped over during this operation. Serious personal injury may occur.
Figure 12. Attaching the miter body.
Figure 13. Installing the quick release lever.
|
|
|
|
|
|
|
|
|
|
|
|
G1531 Edge Sander | |||