Maintenance And
Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
To prevent serious injury from tool failure:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
Cleaning and Maintenance
1.BEFORE EACH USE, inspect the general condition of the tool. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wir- ing, and any other condition that may affect its safe operation.
2.After Use, Brush and wipe exter- nal surfaces of the tool and vacuum if possible.
Dust Bag
Dust Bag
3.If a dust collector is not used, clean out the Dust Bag (273) on a regu- lar basis. (See Fig. “Dust Bag”) The frequency required will depend on hours of use, the type of stock being sanded, and the grit of sandpaper being used.
4.
WARNING! If the power cord of this power tool is damaged, it must be replaced only by a qualified service technician.
SKU 98198 | For technical questions, please call | Page 15 |