Harbor Freight Tools 98198 operating instructions Please Read the Following Carefully

Page 22

Problem

 

Possible Causes

 

Likely Solutions

Sandpaper on

1.

Possibly a nail/staple in

1.

Sand only clean workpieces.

 

workpiece.

 

 

Drum tears

 

 

 

2.

Sandpaper not tightened or

2.

Install the sandpaper correctly.

during operation

 

 

fastened correctly.

 

 

 

1.

Table lift screws are dirty or

1.

Clean and re-grease table lift screws.

Table elevation

 

loaded with sawdust.

 

 

controls are

2. Chain idler sprocket Cap Screws

2.

Adjust the Cap Screws on the Idler Sprocket

stiff and hard to

 

have been over tightened.

 

so it can rotate freely.

adjust.

3.

Elevation handle helical gear is

3.

Clean and re-grease the Helical Cut Gear

 

 

dirty or loaded with sawdust.

 

(113).

Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect power supply before service.

PLEASE READ THE FOLLOWING CAREFULLY

The manufacturer and/or distributor has provided the parts list and assembly diagram in this manual as a reference tool only. Neither the manufacturer or distributor makes any representation or warranty of any kind to the buyer that he or she is qualified to make any repairs to the product, or that he or she is qualified to replace any parts of the product. In fact, the manufacturer and/ or distributor expressly states that all repairs and parts replacements should be undertaken by certified and licensed technicians, and not by the buyer. The buyer assumes all risk and liability arising out of his or her repairs to the original product or replacement parts thereto, or arising out of his or her installation of replacement parts thereto.

SKU 98198

For technical questions, please call 1-800-444-3353.

Page 22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents For technical questions or replacement parts, please call Distributed exclusively by Harbor Freight ToolsContents General Power Tool Safety Save This ManualGfci reduces the risk of electric shock Drum Sanding Operation Safety Warnings For technical questions, please call Grounding Plug and OutletSymbology Extension CordsAssembly SpecificationsList of contents UnpackingOperating Instructions Final AssemblyTool Set Up MountingDepth of cut Work Piece and Work Area Set UpGeneral Operating Instructions Dust BagSandpaper replacement Tools supplied Speed adjustmentSandpaper grit selection chart Grit Class Sanding tipsSanding Belts Cleaning the machineLubrication Belt TensioningFor technical questions, please call Maintenance Servicing Cleaning and MaintenancePulley Alignment Replacing V-beltsFeed Belt Tracking Check rear of the Pressure Plate Adjustment Feed Belt ReplacementConveyor Table Adjustments Check front of the Pressure Plate adjustmentTo adjust the rear Pressure Plate To adjust the front of the Pressure PlateMotor Thermal Circuit Breaker White Black GroundTroubleshooting Problem Possible Causes Likely SolutionsSanding Operations Problem Possible Causes Likely Solutions Please Read the Following Carefully Part Part Name BELTA46 Head Cover Handle Bushing Assembly Diagram Limited 1 year / 90 Day warranty Record Product’s Serial Number Here
Top Page Image Contents