Harbor Freight Tools 92623 operating instructions Sanding, INSPECTION, MAINTENANCE, and Cleaning

Sanding

1.Attach the desired grit Sanding Disk (47 or 48) onto the Polishing Pad (2).

2.Plug the Power Cord (41) of the Polisher/Sander into the electrical extension cord. Then, plug the extension cord into the grounded, GFCI, 120 volt, electrical outlet.

3.Identify the area you wish to sand. Make sure the power cord will reach that far without stressing any connections. Place the Polisher/Sander onto the sanding area.

4.To start, grip the Polisher/Sander firmly with both hands and press in on the Switch (36) trigger. Press the Lock-on Button to lock the Switch in the On position. Press in on the Switch to unlock again.

5.Position the unit on the area to be sanded, select the desired speed by rotating the Speed Adjustment (37) knob (1 through 6), and allow the Sanding Disk (1) to rotate until it has reached that speed. Keep heavy pressure off of the Polisher/Sander when operating. Allow the sanding disk to do the work.

6.Move the Polisher/Sander in a uniform pattern up and down or side to side as you sand to ensure even sanding.

7.Periodically, stop the Polisher/Sander and check for possible disc wear. Replace used or worn sanding discs when necessary.

8.When finished, release the Switch (6) to its Off position. Then unplug the Power Cord

(41)from the electrical extension cord. Unplug the extension cord from the electrical outlet.

INSPECTION, MAINTENANCE, AND CLEANING

WARNING! Make sure the Power Switch of the Polisher/Sander is in its “OFF” posi- tion and that the tool is unplugged from its electrical outlet before performing any

inspection, maintenance, or cleaning procedures.

1.Before each use, inspect the general condition of the Polisher/Sander. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use. Do not use damaged equipment.

2.Periodically recheck all nuts, bolts, and screws for tightness.

3.Store in a clean and dry location.

4.The most common error when waxing/polishing a vehicle is applying too much wax. If the Foam Pad (44) becomes saturated with wax, polishing will be more difficult and will take longer. Applying too much wax may also reduce the life of the Foam Pad. If the Foam Pad continually comes off the Polishing Pad (2) during use, too much wax may have been applied.

Page 11