3.An alternate method of securing the sander to a supporting surface is to fasten the sander base to a mounting board 18" x 24" minimum size. The diagram, shown in Fig. 17, illustrates the size and center to center distance of the holes to be drilled in the mounting board. NOTE: For proper stability, the holes in the mounting board must be countersunk at the bottom so screw heads are flush with bottom surface of the mounting board.
Fig. 17
4.Securely clamp the mounting board to a stand or workbench using 2 or more “‘C” clamps, as shown in Fig. 18.
IMPORTANT: If there is any tendency for the stand or workbench to move during operation, the stand or work- bench must be fastened to the floor.
Fig. 18
OPERATING CONTROLS
AND ADJUSTMENTS
STARTING AND
STOPPING SANDER
The switch (A) Fig. 22, is located on the sander base. To turn the sander “ON” move the switch up to the “ON” position. To turn the sander “OFF” move the switch down to the “OFF” position.
A
Fig. 22
11