Delta SA446 instruction manual Assembling Sanding Disc, Assembling Lower Cover for Sanding Disc

Page 9

ASSEMBLING

SANDING DISC

1.Make sure sanding disc plate (A) Fig. 9, is clean.

2.Peel backing from sanding disc and press disc (B) firmly into position all the way around the sanding plate, as shown in Fig. 9.

ASSEMBLING LOWER COVER FOR SANDING DISC

Assemble the lower cover (A) Fig. 10, to the belt and pulley guard, using the three M4x.7x12mm sheet metal screws (B).

ASSEMBLING

DISC SANDER TABLE

1.Thread a M8x1.25x20mm hex socket head screw

(A) Fig. 11, part-way into threaded hole in base of sander and insert rod (B) into hole as shown. Align flat on rod (B) with screw (A) and tighten screw (A).

2.Slide table assembly (C) Fig. 12, onto rod (B) as shown.

3.Thread M8x1.25x20mm hex socket head screw (D) Fig. 12, into hole in table support bracket as shown. Align flat on rod (B) with screw (D) and tighten screw (D).

4. WARNING: TO AVOID TRAPPING THE WORK

OR FINGERS BETWEEN THE TABLE AND SANDING DISC, THE TABLE EDGE (E) FIG. 12, SHOULD BE PO-

SITIONED A MAXIMUM OF 1/16" AWAY FROM SANDING DISC (F). LOOSEN SCREW (D) AND ADJUST TABLE ACCORDINGLY.

A

B

Fig. 9

A B

Fig. 10

A

B

Fig. 11

F

E

C

B

D

Fig. 12

9

Image 9
Contents Belt / 6 Disc Sander General Safety Rules Refer to them often Use them to instruct others Additional Safety Rules for Belt / Disc SandersPower Connections Extension Cords Unpacking and CleaningSander Parts Belt / 6 Disc Sander PartsAdjusting Belt Tension Assembly InstructionsAssembling Sanding Disc Plate Assembling Belt Pulley GuardAssembling Sanding Disc Assembling Lower Cover for Sanding DiscAssembling Disc Sander Table Fastening Sander to Supporting Surface Assembling Dust ChuteAssembling Backstop to Sanding ARM Starting Stopping Sander Operating Controls AdjustmentsLocking Switch OFF Position Tracking Sanding BeltChanging Position of Sanding ARM Adjusting Backstop Square With Sanding Belt Adjusting Table Square with Sanding DiscTilting the Table Miter Gage Adjusting Miter Gage Slot Parallel with Sanding DiscWrench Storage Dust ChuteReplacing Sanding Disc Replacing Sanding BeltSurfacing or Edge Sanding With Sanding Belt OperationSanding Outside Curves Sanding Inside CurvesEND Sanding With the Belt END Sanding With the DiscPage Two Year Limited Warranty Accessories PARTS, Service or Warranty Assistance