USING TABLE ASSEMBLY WITH SANDING BELT
When the sanding arm (A) Fig. 36, is used in the vertical position, the complete table assembly (B) can be moved from the disc unit to the belt unit as follows:
1.DISCONNECT MACHINE FROM POWER SOURCE.
2.Remove the backstop (C) Fig. 36.
3.Thread the M8x1.25x20mm hex socket head screw
(D) Fig. 36, into base casting as shown. NOTE: Only thread screw (D) partway into base casting.
4.Loosen screw (E) Fig. 36, and remove table assembly (B) from disc unit. Insert bar (F) into hole (G) on belt unit and tighten screw (D).
5.Fig. 37, illustrates the table assembly (B) assembled to the belt unit.
WARNING: THE TABLE EDGE (G) MUST BE POSITIONED A MAXIMUM OF 1/16 INCH AWAY FROM THE SANDING BELT (H) TO AVOID TRAPPING THE WORK OR FINGERS BETWEEN THE TABLE AND SANDING BELT.
DUST CHUTE
A dust chute (A) Fig. 38, is supplied with your sander and can be connected to a standard shop vacuum hose. The outside diameter of the opening of the dust spout is 2- 1/2 inches.
WRENCH STORAGE
Two holes are provided in the base casting and are used for storing the two wrenches (A) Fig. 39, supplied with the sander.
A
C
D
G
B
F
E
Fig. 36
H 
G
B
Fig. 37
A 
Fig. 38
A
Fig. 39
15