ASSEMBLING BELT
AND PULLEY GUARD
Assemble belt and pulley guard (A) Fig. 8, to the machine using two M6 x 55mm hex socket head screws (B), M6.4 lockwashers and M6.4 flat washers as shown. NOTE: Make certain plug (C) is installed into guard.
ASSEMBLING SANDING DISC PLATE
1.Slide sanding disc plate (A) Fig. 9, onto drive shaft
(B) making certain key (C) in drive shaft (B) fits into keyway (D) of disc plate (A).
2.Slide sanding disc plate (A) Fig. 10, onto shaft until surface of disc plate and drive shaft (B) are nearly flush. Shaft (B) must not extend out past plate surface.
3.Insert hex wrench (E) Fig. 11, down through slot (F) in the back of belt and pulley guard (G) and tighten set screw holding disc plate on drive shaft.
A
B
A
B
C
Fig. 8
C
A D
B
Fig. 9
E
F
G
Fig. 10
ASSEMBLING SANDING DISC TO DISC PLATE
1.Make certain sanding disc plate (A) Fig. 12, is clean.
2.Peel backing from sanding disc (B) Fig. 12, and press disc firmly into position all around the sanding disc plate (A) as shown.
Fig. 11
A B
Fig. 12
8