ACCESSORY MITER GAGE
An accessory miter gage is available for your machine and is used with the disc table. The miter gage body (A) Fig. 32, can be tilted right or left for angle or miter sanding by loosening lock knob (B), and rotating miter gage body to the desired angle. Tighten lock knob (B).
USING TABLE ASSEMBLY WITH SANDING BELT
When the sanding arm (A) Fig. 33, is in the vertical position, the complete table assembly (B) can be moved from the disc unit to the belt unit as follows:
1.Remove backstop (C) Fig. 33, from the machine.
2.Loosen screw (D) Fig. 33, and carefully remove sup- port bar (E) and table assembly (B) from the disc unit.
3.Loosen set screw (F) Fig. 34, and insert support bar
(E) and table assembly (B) into hole (G) Figs. 33 & 34, on belt unit. Tighten set screw (F) to hold support bar and table assembly in position.
WARNING: THE TABLE EDGE (H) FIG. 34, MUST BE POSITIONED A MAXIMUM OF 1/16" AWAY FROM SANDING BELT (J) TO AVOID TRAPPING THE WORK OR FINGERS BETWEEN THE TABLE AND SANDING BELT.
DUST SPOUT
A dust spout (A) Fig. 35, is supplied with your sander and can easily be connected to a standard shop vacuum hose. The inside diameter opening of the dust spout (A) is
B
A
Fig. 32
A
C
G
D
B
E
Fig. 33
J |
H |
B |
G |
E |
F |
Fig. 34
A
Fig. 35
13