Schumacher SI263 manual Charging Tips

Page 23

Charging Tips

Read the entire manual before using the Battery Manager. The tips below serve only as a guide for specific situations.

Reviving a Battery: To charge your battery enough to start your vehicle, it is not necessary to wait for the entire charging process to be completed. When the battery status displays 3 yellow LEDs, the battery is usually charged enough for the vehicle to start normally.

Completing an Interrupted Charge: If the charging process has been interrupted and restarted after the Battery Manager displays a battery status of 4 yellow LEDs, the Battery Manager may enter Maintain Mode. However, if the original charge was started using the 6A rate, the charge can often be completed using the 2A rate.

23

SI263 IM 0205v1.indd 23

3/2/05 4:41:08 PM

Image 23
Contents Intelligent Battery Manager Dear Sharper Image Customer Table of Contents Table of Contents Important Safety Precautions SI263 IM 0205v1.indd 05 44107 PM SI263 IM 0205v1.indd 05 44107 PM SI263 IM 0205v1.indd 05 44107 PM Personal Safety Precautions Charging Preparation PowerFeatures Extension Cord Minimum Recommended Extension Cord UseBattery Preparation Operation Charging Battery in the VehicleSI263 IM 0205v1.indd 05 44108 PM Negative-Grounded System Standard Positive-Grounded System Charging a Removed Battery Charging a Removed Battery Charge Rate Operating FeaturesBattery Type Button General Notes Charging Tips Maintenence and Care Problem Possible Cause Solution TroubleshootingTroubleshooting Problem Charged LED Problem Possible Cause Solution Statement of FCC Compliance FCC Label Compliance Statement Warranty