Schumacher Speedcharge Control, SC-6000A Control Panel Display Mode Switch, Charge Rate Switch

Page 8

SPEEDCHARGE CONTROL

SC-6000A CONTROL PANEL

DISPLAY MODE SWITCH

Use this switch to set the function of the digital LED to one of the following three.

run down battery. Always use in combination with a battery.

BATTERY TYPE SWITCH

•BATTERY %: The digital LED displays an estimate of the percent of charge of the battery connected to the SpeedCharge battery clamps.

•VOLTAGE: The digital LED displays the voltage at the SpeedCharge battery clamps in DC volts.

•ALTERNATOR %: The digital LED displays an estimate of the output of the vehicle charging system con- nected to the SpeedCharge battery clamps as compared to a properly functioning system.

CHARGE RATE SWITCH

Use this switch button to set the charge rate to one of the following three.

•2A CHARGE RATE: Intended for charging small batteries such as those commonly used in garden tractors, snow mobiles and motor- cycles. The 2A rate is not intended to be used as a trickle charger for larger batteries.

•30A￿￿10A CHARGE RATE: Use for charging automotive batteries, marine batteries, and deep cycle batteries. Not intended for industrial applications.

•60A START: Provides 60 amps for cranking an engine with a weak or

Use this switch button to set the type of battery to be charged to one of the following three.

•DEEP CYCLE: Deep cycle batteries are usually marked as “deep cycle” or “marine”. Deep cycle batteries are usually larger than the other types.

•AGM, GEL CELL: AGM and gel cell batteries have sealed cases without vent caps. Such batteries are often smaller than the other types.

•REGULAR: This is the type of battery usually used in cars, trucks, and motorcycles. These batteries have vent caps and are often marked “low maintenance” or “maintenance-free”.

With the exception of AGM and gel cell batteries, all other battery types may or may not have vent caps. Vent caps are located on top of the battery and provide a means to add distilled water when needed. Batteries should be marked with their type. If charging a battery that is not marked, check the manual of the item that uses the battery. If the battery type is unknown, use the REGULAR setting. Make sure the battery complies with the safety instructions on page 3.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Electric Corporation Table of Contents Important Safety Instructions Help US Help YOUPersonal Safety Precautions Before Using Your Battery Charger Preparing Your Battery to be ChargedUsing AN Extension Cord Plugging ITCharging Battery in the Vehicle Connecting to a positive-groundedOperating Instructions Negative Grounded SystemCharging Battery Removed from the Vehicle Using Engine StartSC-6000A Control Panel Display Mode Switch Battery Type SwitchCharge Rate Switch Speedcharge ControlMode of Operation CellDigital DisplayUsing the BUILT-IN Battery Tester Using the BUILT-IN Alternator Tester Using Your Engine StarterAlternator Testing Notes Starting SequenceUsing Your Battery Charger Engine Starting Notes30A Charge Rate When set to Charging TipsBattery Percent and Charge Time Problem Possible Cause Solution TroubleshootingMaintenance and Care Limited Warranty

SC-6000A specifications

The Schumacher SC-6000A is an advanced battery charger and maintainer designed for optimal performance in charging automotive batteries. This device is an essential tool for both automotive enthusiasts and everyday drivers who wish to ensure their battery is always charged and ready for use.

One of the standout features of the SC-6000A is its microprocessor-controlled technology, which allows it to automatically adjust the charging rate based on the battery’s needs. This intelligent charging system not only enhances battery life but also ensures faster charging times, making it both efficient and effective.

The unit is compatible with various battery types, including both lead-acid and AGM (Absorbent Glass Mat) batteries, which provides versatility for users with different vehicles or battery setups. The SC-6000A supports a wide voltage range, making it suitable for 6V and 12V batteries, further broadening its usability across different automotive applications.

Safety is a top priority with the SC-6000A. It incorporates multiple safety features that protect against overload, short circuits, and reverse polarity, ensuring that users can operate the device without fear of damaging their batteries or the charger itself. Additionally, it comes with an automatic shut-off function that prevents overcharging, adding another layer of security during charging cycles.

The SC-6000A is lightweight and portable, making it easy to store and carry. Its user-friendly interface, equipped with LED indicators, provides clear insights into the charging status and battery condition. This allows users to monitor the process effectively without complicated setups.

Moreover, this charger includes a battery maintainer function that is particularly beneficial for vehicles that are not used regularly. This feature can help in maintaining battery health over long periods, preventing sulfation, which can lead to reduced battery life.

In summary, the Schumacher SC-6000A is a reliable and versatile battery charger that stands out in the market for its smart technology, safety features, and compatibility with various battery types. Whether for routine battery maintenance or emergency charging, the SC-6000A proves to be a valuable asset for any vehicle owner.
Top Page Image Contents