Invacare P9000 XDT manual Replacing the Batteries, Connecting the Battery Charger

SECTION 11—BATTERIES

Connecting the Battery Charger

NOTE: For this procedure, refer to FIGURE 11.2.

1.Attach the battery charger connector to the charger port on the joystick.

2.Plug the charger’s AC power cord, or extension, into the grounded 120 VAC wall outlet.

3.Wait until charging is complete.

NOTE: If the batteries need to be charged more often or take longer to charge than normal, they may need to be replaced. Contact an Invacare dealer for service.

Charger

Port

FIGURE 11.2 Connecting the Battery

Charger

Replacing the Batteries

WARNING

Most batteries are not sold with instructions. However, warnings are frequently noted on the cell caps. Read them carefully, otherwise injury or damage can occur.

The use of rubber gloves and chemical goggles or face shields is recommended when working with batteries.

NOTE: Invacare recommends that both batteries be replaced if one (1) battery is defective.

Recommended Battery Types

WARNING

The warranty and performance specifications contained in this manual are based on the use of deep cycle gel cell or sealed lead acid batteries. Invacare strongly recommends their use as the power source for this unit.

CAUTION

Failure to use the correct battery size and/or voltage may cause damage to your wheelchair and give you unsatisfactory performance.

CHAIR SEAT	QTY	VOLTS	BATTERY	REMARKS
WIDTH			SIZE
18- inches	2	12	U1	Deep Cycle
18-inches	2	12	Group 22NF	Deep Cycle

1.Remove the battery boxes and tray from the wheelchair. Refer to Removing/Installing the Battery Boxes on page 50 and Installing/Removing Battery Tray on page 51.

Part No. 1118386 49 P9000™ XDT