PREPARATION

SETTING-UP PROJECTOR

CONNECTING AC POWER CORD

This projector uses nominal input voltages of 100-120 V or 200-240 V AC. This projector automatically selects the correct input voltage. It is designed to work with single-phase power systems having a grounded neutral conductor. To reduce risk of electrical shock, do not plug into any other type of power system.

Consult your authorized dealer or service station if you are not sure of the type of power being supplied.

Connect the projector with all peripheral equipment before turning the projector on. (Refer to pages 11 ~ 13 for connection.)

CAUTION

For safety, unplug AC Power Cord when the projector is not in use.

When this projector is connected to an outlet with AC Power Cord, it is in Stand-by mode and consumes a little electric power.

Connect AC Power Cord (supplied) to the projector. The AC outlet must be near this equipment and must be easily accessible.

NOTE ON THE POWER CORD

The AC Power Cord must meet the requirement of the country where you use the projector. Confirm the AC plug type with the chart below. The proper AC power cord must be used. If the supplied AC Power Cord does not match the AC outlet, contact your sales dealer.

Projector side

 

 

AC Outlet side

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

For the U.S.A. and Canada

For Continental Europe

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Ground

 

 

To the POWER CORD

 

 

 

 

 

To the AC Outlet.

 

 

CONNECTOR on the

 

 

 

 

(120 V AC)

 

To the AC Outlet.

projector.

 

 

 

 

 

(200 - 240 V AC)

 

 

 

 

 

 

 

8

Page 8
Image 8
Eiki MODEL LC-SB10 SETTING-UP Projector, Connecting AC Power Cord, For Continental Europe, For the U.S.A. and Canada