Schumacher IP-95L Volt AC Power Source Chart, Using the BUILT-IN Swivel Light, Storage

Page 2

Appliance Type

Estimated Wattage

Estimated Time*

Electrical Tools

24 Watts

4

Hours

Electrical Coolers

48 Watts

1.5

Hours

Car Vacuum,

 

 

 

Air Compressors

80 Watts

45 Minutes

The DC socket has a 15 amp automatic overload protection circuit breaker. Reset the breaker by pushing the breaker button located on the back of IP-95L.

110 Volt AC Power Source Chart

(Inverter {Not Included} Is Necessary)

Appliance Type

Estimated Wattage

Estimated Time*

Spot Lights, Sump Pumps 100 Watts

45 Minutes

VCRs

100 Watts

45 Minutes

Faxes, TVs

125 Watts

35 Minutes

Small Power Tools

125 Watts

35 Minutes

When the IP-95L is used with an inverter, it can operate appliances normally powered by 110V AC. (Inverter not included; must be purchased separately.)

*NOTE: Estimated time is conservatively reported. Actual time may vary. Times are based on IP-95L having a full charge. Requires the use of an inverter that is not included. Designed for up to a 125 watt inverter.

USING THE BUILT-IN SWIVEL LIGHT

The built-in swivel light is located on the left side of the IP-95L. With a fully charged internal battery, the built-in light should provide 18 to 26 hours of continuous useful light, depending on ambient conditions.

1.Position the IP-95L on a flat, stable surface near the intended work area.

2.Pull tab up to remove light from storage. Turn light in direction needed.

3.To turn light ON, push black button above light.

4.To turn light OFF, push the black button.

Important: Turn off light before placing light in its storage space otherwise battery drain occurs.

5.Charge IP-95L as soon as possible after using built-in light.

REPLACING THE BUILT-IN SWIVEL LIGHT BULB

1.Turn light off.

2.Carefully unscrew the back plate of the lamp housing.

3.Gently grasp the bulb and twist until notch in bulb lines up with retaining tab.

4.Insert a replacement bulb of same type and rating, and twist clockwise one quarter-turn to screw in new bulb.

5.Carefully screw on the back plate of the lamp housing.

6.Test light by switching light on and off.

7.Replace lens cover if necessary.

STORAGE

The IP-95L can be stored in any position. The clamps are live and will produce arcing or sparking if they come in contact with each other. To prevent accidental arcing, always keep the clamps on the side ears when not using it to jump start a vehicle.

All batteries are affected by temperature. The ideal storage temperature is at 70 degrees Fahrenheit. Performance varies based on battery temperature conditions.

LIMITED WARRANTY

Schumacher Electric Corporation warrants your unit to be free from defects in material and workmanship, excepting abuse or misuse, for a period of one year from the date of sale to the original user or consumer purchaser. If your unit fails or malfunctions within the first 30 days of the warranty, we will replace it with a new unit. If your unit malfunctions or fails within the 12 month warranty period because of a defect in material or workmanship, we will repair without charge.

The internal battery, excluding units with swollen batteries or melted battery terminals, carries a 90-day warranty from the date of purchase. Proof of purchase required. All battery replacements will be at the sole discretion of the manufacturer or his designated agents.

This warranty is in lieu of all other express warranties. The duration of any implied warranty, including but not limited to any implied warranty of merchantability or fitness for a particular purpose, made in respect to your unit is limited to the period of the express warranty set forth above.

For warranty service, return your product, with proof of purchase, to the factory or a designated agent: Schumacher Electric Corporation Warranty Service

Department, 1025 E. Thompson Street, PO Box 280, Hoopeston, IL 60942. Phone 1-800-621-5485, Customer Service hours: 7 AM to 4:30 PM CST.

You will be responsible for all insurance and freight or other transportation charges to the factory or point of repair. We will return your unit freight prepaid if repair is covered under warranty. Your unit should be properly packed to avoid damage in transit, since we will not be responsible for any such damage.

In no event shall Schumacher Electric Corporation be liable for consequential or incidental damages. Some states do not allow limitations on the length of the implied warranty or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state.

CONTAINS SEALED NON-SPILLABLE LEAD-ACID BATTERY. MUST

BE DISPOSED OF PROPERLY.

WARNING: Possible explosion hazard. Contact with battery acid may cause severe burns and blindness. Keep out of reach of children.

801 Business Center Drive, Mount Prospect, IL 60056-2179

Send Warranty Product Repairs to: Schumacher Electric Corporation

1025 East Thompson, Hoopeston, IL 60942-0280

Call Customer Service if you have questions: 1-800-621-5485 (Hours: 7 a.m. – 4:30 p.m. CST)

Image 2
Contents LED Indicators Instant Power Jump Starter & DC Power SourceImportant Safety Instructions MULTI-PURPOSE Power SupplyLimited Warranty Volt AC Power Source ChartUsing the BUILT-IN Swivel Light Replacing the BUILT-IN Swivel Light BulbAide-démarrage, et source d’alimentation Instant PowerGuide DE L’UTILISATEUR Instructions Importantes Relatives À LA SécuritéTableau DE Source D’ALIMENTATION DE Volts CA Remplacement DE L’AMPOULE DE LA Lampe Pivotante IntégréeTableau DE LA Prise D’ALIMENTATION DE 12 Volts CC Utilisation DE LA Lampe Pivotante IntégréeGarantie Limitée Instrucciones Importantes DE Seguridad Instant POWER, Arranque Inmediato y Fuente de Potencia CCManual DEL Dueño Guarde estas instruccionesCarta DEL Fuente DE Potencia 110 CA Fuente DE Potencia MultipropósitoCarta DEL Tomacorriente DE Potencia DE 12 Voltios CC USO DE LA LUZ Giratoria IntegradaGarantía Limitada