Haier 311209J important safety instructions Fire and Explosion Hazard

Page 4

Warnings

WARNING

FIRE AND EXPLOSION HAZARD

Flammable fumes, such as solvent and paint fumes, in work area can ignite or explode. To help prevent fire and explosion:

• Use equipment only in well ventilated area.

• Eliminate all ignition sources; such as pilot lights, cigarettes, portable electric lamps, and plastic drop cloths (potential static arc).

• Keep work area free of debris, including solvent, rags and gasoline.

Do not plug or unplug power cords, or turn power or light switches on or off when flammable fumes are present.

Ground all equipment in the work area. See Grounding instructions.

Use only grounded hoses.

Hold gun firmly to side of grounded pail when triggering into pail.

If there is static sparking or you feel a shock, stop operation immediately. Do not use equipment until you identify and correct the problem.

Keep a working fire extinguisher in the work area.

EQUIPMENT MISUSE HAZARD

Misuse can cause death or serious injury.

Do not operate the unit when fatigued or under the influence of drugs or alcohol.

Do not exceed the maximum working pressure or temperature rating of the lowest rated system component. See Technical Data in all equipment manuals.

Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data in all equipment manuals. Read fluid and solvent manufacturer’s warnings. For complete information about your material, request MSDS forms from distributor or retailer.

Check equipment daily. Repair or replace worn or damaged parts immediately with genuine manu- facturer’s replacement parts only.

Do not alter or modify equipment.

Use equipment only for its intended purpose. Call your distributor for information.

Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.

Do not kink or over bend hoses or use hoses to pull equipment.

Keep children and animals away from work area.

Comply with all applicable safety regulations.

TOXIC FLUID OR FUMES HAZARD

Toxic fluids or fumes can cause serious injury or death if splashed in the eyes or on skin, inhaled, or swallowed.

Read MSDS’s to know the specific hazards of the fluids you are using.

Store hazardous fluid in approved containers, and dispose of it according to applicable guidelines.

MOVING PARTS HAZARD

Moving parts can pinch or amputate fingers and other body parts.

Keep clear of moving parts.

Do not operate equipment with protective guards or covers removed.

Pressurized equipment can start without warning. Before checking, moving, or servicing equipment, follow the Pressure Relief Procedure in this manual. Disconnect power or air supply.

4

311209J

Image 4
Contents Hot Melt Dispense Guns Contents ModelsBurn Hazard Fire and Explosion Hazard Installation Connect Heated HoseConnect Electrical Cable Adapter Hose SizeGround the System Pressure Relief Procedure Trigger LockOperation HeatupDispensing ShutdownTroubleshooting Problem Causes SolutionsService Install New Heater Cartridges, RTD Sensor, or SwitchAdjust Needle Assembly Service Valve Stem and SealInspection Frequency 311209J Parts Models 249514 and 249512, Hot Melt GunsHandle Part No. Description QtyModels 249515 and 249513, Hot Melt Guns Models 249515 and 249513, Hot Melt Guns54‡ 102273 SCREW, 6-32 x 55‡ SCREW, 4-40 x Models 297274 and 297273, Hot Melt Guns Models 297274 and 297273, Hot Melt Guns15G019 SPACER, cover mounting 112699 Accessories DescriptionTechnical Data Graco Standard Warranty Graco Information