Sanyo C2432, CL2432 Mounting Right-side tubing, If using a stepladder, be careful, Hold in place

3-9. Mounting

■Right-side tubing

(1)Shape the refrigerant tubing so that it can easily go into the wall hole. (Fig. 24)

CAUTION	If using a stepladder, be careful
	to keep your balance and not
	fall off. To prevent the unit
	from damage and avoid per-
	sonal injury, ask for someone’s
	help when feeding the tubing
	through the hole because the
	unit is heavy and difficult to
	hold in place.

Cover

Refrigerant tubing

Inter-unit wiring

Drain hose

Fig. 24

(2)	Push the wiring, refrigerant tubing, and drain hose
	through the hole in the wall. Adjust the indoor unit so
	it is securely seated on the rear panel.
(3)	Carefully bend the tubing (if necessary) to run along

Pipe bending tool

b

a

b / a = 0.7 or more

the wall in the direction of the outdoor unit and then

tape as far as the fittings.

CAUTION	The air conditioner’s perfor-
	mance will be deteriorated if a
	tube is crushed. To prevent
	crushing of the tube, avoid
	sharp bends. Use a pipe bend-
	ing tool to bend the tube.
	(Fig. 25)

(4)Connect the refrigerant tubing to the outdoor unit. (After performing a leak test on the connecting part, insulate it with tubing insulation. (Fig. 26)) Also, refer to Section 4-3. Connecting Tubing between Indoor and Outdoor Units.

(5)Assemble the refrigerant tubing, drain hose, and inter-unit wiring as shown in Fig. 27.

Fig. 25

Insulation (Field supply)

Fig. 26

Refrigerant tubing

Conduit Drain hose

Inter-unit wiring

Fig. 27

11