Sanyo C2432, CL2432 installation instructions How to Install the Indoor Unit

3. How to Install the Indoor Unit

3-1. Remove the Rear Panel from the Unit

Remove and discard the set screws and take off the rear panel. (Fig. 6)

NOTE

Tubing can be extended in 3 directions as shown in Fig. 7a. Select the direction you need providing the shortest run to the outside unit.

3-2. Make a Hole

(1)Remove the rear panel from the indoor unit and place it on the wall at the location selected. Make sure the unit is horizontal, using a carpenter’s level or tape measure to measure down from the ceiling.

(2)Determine which side of the unit you should make the hole. (Fig. 7b)

(3)Before making a hole, check carefully that no studs or pipes are directly run behind the spot to be cut.

CAUTION	Also avoid areas where electri-
	cal wiring or conduits are
	located.

The above precautions are also applicable if tubing goes through the wall in any other location.

(4)Using a sabre saw, key hole saw or hole-cutting drill attachment, cut a hole in the wall. See Table 4 and Fig. 8.

Table 4

Hole Dia. (inch)

3-3/16"

(5)Measure the thickness of the wall from the inside edge to the outside edge and cut PVC pipe at a slight angle 1/4" shorter than the thickness of the wall. (Fig. 9)

(6)Place the plastic cover over the end of the pipe (for indoor side only) and insert in the wall. (Fig. 10)

PVC pipe (locally purchased)

Cut at slight angle

Fig. 9

Set screws for transportation only

	Fig. 6
Left-rear tubling	Right-rear
	tubing
	(recommended)

Right tubing

Fig. 7a

In case of left-rear or right-rear tubing

Center of	Center of
left-rear	right-rear
tubing hole	tubing hole

Fig. 7b

NOTE

Hole should be made at a slight downward slant to the outdoor side.

Indoor Outdoor

side side

	Fig. 8
INSIDE	OUTSIDE
Plastic cover	Wall
	PVC pipe
(Field Supply)
	Slight
	angle

Fig. 10

5