Assembling VISLIDER
1. Assembly and fitting of rod handle
Remove the hexagon fitting bolt and the washer from the handle rod. To the handle rod, fit the handle bar, the washer and the hexagon bolt in this order. Tighten the hexagon fitting bolt using the 13mm spanner.
Mount the assembled rod handle on the rear of the main body. Tighten the two fitting screws using the 6mm wrench.
2.Fitting and removal of magazine
To fit the magazine, insert the magazine holder into the bracket at top end of the main body until it clicks.
To remove the magazine, withdraw it while pulling the magazine stopper with fingers.
2