![](/images/new-backgrounds/1108759/10875999x1.webp)
AC filter cable assembly
The AC filter cable assembly consists of two cables leading from separate power supply input connectors near the front of the chassis and ending in an AC filter and inlets at the rear of the chassis.
To remove the AC filter cable:
1.Power down the server. See “Powering down the server” earlier in this chapter.
2.Remove all power supplies. See
NOTE: Label the individual hard drives before pulling them out.
3.Remove all the
4.Extend the server from the rack. See “Extending the server from the rack” earlier in this chapter. Although not required, HP recommends removing the server from the rack for best performance. See “Removing the server from the rack” earlier in this chapter.
5.Remove the access panel. See “Removing the access panel” earlier in this chapter.
6.Remove the processor memory boards. See “Processor memory boards” earlier in this chapter.
7.Remove the SCSI cables. See “SCSI cables” earlier in this chapter.
8.Remove the
9.Remove the front fan cage. See “Front fan cage” earlier in this chapter.
10.Remove the rear fan cage. See “Rear fan cage” earlier in this chapter.
11.Remove the
12.Remove the SCSI backplane. See “SCSI backplane” earlier in this chapter.
13.Remove the BBWC assembly. See
14.Remove the system board. See “System board” located earlier in this chapter.
15.Cut the four