Removing the access panel
WARNING! Pressing the Power On/Standby button sets the server to the standby position, which removes power from most areas of the server. However, portions of the power supply and some internal circuitry remain active until the AC power cord is removed.
WARNING! To reduce the risk of personal injury from hot surfaces, allow the internal system components to cool before touching.
CAUTION: Electrostatic discharge can damage electronic components. Properly ground yourself before beginning any installation procedure.
1.Power down the server. See “Powering down the server” earlier in this chapter.
2.Extend the server from the rack. See “Extending the server from the rack” earlier in this chapter.
3.Unlock the access panel latch .
4.Lift up on the latch (2), and remove the access panel .
Figure 8 Removing the access panel
Installing the access panel
1.Place the access panel on top of the server with the latch open. Allow the panel to extend past the rear of the server approximately 1.25 cm (0.5 inches).
2.Push down on the latch. The access panel slides to a closed position.
