Sanyo RCS-SH1UA, RCS-SH80UA.WL Care and Cleaning, Air filter How to clean the filter

Page 16

Care and Cleaning

Air Intake and outlet side (Indoor Unit)

Air filter

NOTETE

How to clean the filter

How to remove the filter

4-way semi-concealed type (X):

1.For safety, be sure to turn the air conditioner off and also to disconnect the power before cleaning.

2.Do not pour water on the indoor unit to clean it. This will damage the internal components and cause an electric shock hazard.

Clean the air intake and outlet side of the indoor unit with a vacuum cleaner brush, or wipe them with a clean soft cloth.

If these parts are stained, use a clean cloth moistened with a mild liquid detergent. When cleaning the air outlet side, be careful not to force the vanes out of place.

1.Never use solvents or harsh chemicals when cleaning the indoor unit. Do not wipe plastic parts using very hot water.

2.Some metal edges and the fins are sharp and may cause injury if handled improperly; be especially careful when you clean these parts.

3.The internal coil and other components of the outdoor unit must be cleaned every year. Consult your dealer or service center.

The air filter collects dust and other particles from the air and should be cleaned at regular intervals as indicated in the table below or when the filter indication ( ) on the display of the remote control unit (wired type) shows that the filter needs cleaning. If the filter gets blocked, the efficiency of the air conditioner drops greatly.

Type

X

T

K

U

Period

Six months

Six months

Two weeks

(depending on

 

 

 

 

filter specifications)

*Concealed duct type (U):

An air filter is not provided with this air conditioner at the time of shipment. To get clean air and to extend the service life of the air conditioner, an air filter must be installed in the air intake. For installation and cleaning the air filter, consult your dealer or service center.

The frequency with which the filter should be cleaned depends on the environment in which the unit is used.

1.Remove the air filter from the air intake grille.

2.Use a vacuum cleaner to remove light dust. If there is sticky dust on the filter, wash the filter in lukewarm, soapy water, rinse it in clean water, and dry it.

1.Remove the bolt screw on each side out of the latch using a screwdriver. (After cleaning, be sure to reattach the two bolt screws.)

2.Slide the two latches of the air intake grille to the direction of the arrow to open the grille.

3.Open the air intake grille downward.

When cleaning the air filter, never remove the safety chain. If it is necessary to remove it for servicing and maintenance inside, be sure to reinstall the safety chain securely (hook on the grille side) after the work.

1

1 - 15

Image 16
Contents RCS-SH1UA RCS-SH80UG Contents Installation Location Wired type Type 4-WAY Celling panel Optional Air outlet Air intakeType Air outlet Air intake Available for all Indoor unitsSetting Mode buttonSET button ButtonCool mode and dry mode, when the flaps are set in a Timer SET buttonOFF Timer OFF Cycle TimerRemote Control Unit Display Remote Control Unit DescriptionSetting the mode Setting the fan speedSetting the temperature Setting the airflow directionSemi-concealed type Way type Ceiling mounted type T Auto flapVertical directions automatic Horizontal directions manualWall mounted type K Vertical directions automatic Concealed duct type USpecial Remarks Setting the Timer OFF cycle TimerONOperation IndicationCare and Cleaning Air filter How to clean the filterSafety chain Cleaning, be sure to attach the two bolt screwsRemove the air filter attached to the air intake grille LatchShould the power fail while the unit is running Trouble Possible Cause RemedyRCS-SH80UA.WL RCS-BH80UA.WL RCS-SH1UA Contents Product InformationSafety Instructions Installation LocationElectrical Requirements Remote control receiver Lamp Operation lampStandby lamp Operation controllerSwitch Address switchServicing switches Sweep buttonAutomatically How to Install Batteries Direction marked in the battery compartmentTime, on time, and OFF time are all reset to Direction of the arrowInstallation fitting of wireless remote control unit Place 1here PressTemperature Setting buttonsRemote Cotrol Unit Only for heat pump typeOFF Timer OFF Cycle TimerVent Do not move the flap with your hands SET buttonALL Clear Indication DescriptionSetting the fan speed Setting the temperatureSetting the airflow direction To start the air conditionerOperation without the Wireless Remote Controller Press the ON/OFF operation button againShould the power fail while the unit is running Heating performance DefrostingSetting the Timer TimerOn timer OFF cycleHow to set the OFF timer OperationTroubleshooting 2Tips for Energy SavingTrouble Possible Cause Remedy Obstructed, the unit will not work well, and may be damagedSHA-KC64UG Alert Symbols Installation Location How to Use the System Controller ALL/ZONE/GRCool mode and dry mode, when the flaps are set in a Functions of buttons On buttonOFF button FAN Speed buttonFollows Do not use the SET button for normal operationDisplay Description Stop Power How to start group operationStop How to start collective operation Set the operation mode by pressing the Mode buttonPage Page Sanyo Fisher Company

RCS-BH80UA.WL, RCS-SH80UA.WL, RCS-SH1UA specifications

Sanyo, a renowned brand known for its innovative heating and cooling solutions, offers a robust lineup of air conditioning systems, notably the models RCS-SH1UA, RCS-SH80UA.WL, and RCS-BH80UA.WL. These models are designed to provide efficient climate control solutions for both residential and commercial applications, emphasizing energy efficiency, comfort, and advanced technology.

The Sanyo RCS-SH1UA is a standout unit equipped with powerful heating and cooling capabilities ideal for varied environments. This compact split system offers a sleek design, making it suitable for small spaces while delivering substantial HVAC performance. One of its significant features is the advanced inverter technology, which adjusts the power consumption based on the current heating or cooling demand, ensuring consistent comfort and energy savings.

On the other hand, the RCS-SH80UA.WL and RCS-BH80UA.WL models are equipped with advanced features to enhance user experience. Both units boast high energy efficiency ratings, which are crucial for reducing electricity bills while minimizing environmental impact. These models incorporate innovative airflow systems that ensure uniform air distribution, creating a pleasant indoor environment regardless of outside conditions.

Both RCS-SH80UA.WL and RCS-BH80UA.WL are designed with user-friendly controls. The inclusion of remote control options allows for convenient adjustments without needing to be near the unit. Additionally, the air conditioning units come with programmable timers and multiple fan speeds, enabling users to fine-tune their climate control experience.

Another noteworthy characteristic across these Sanyo models is their whisper-quiet operation. Designed to minimize noise, they provide a tranquil atmosphere, making them suitable for bedrooms, offices, and other quiet spaces. Furthermore, the air-purifying technologies integrated into these units enhance indoor air quality by reducing pollutants and allergens, promoting a healthier living environment.

In conclusion, the Sanyo RCS-SH1UA, RCS-SH80UA.WL, and RCS-BH80UA.WL air conditioning systems symbolize a blend of efficiency, technology, and user-centric design. With their advanced features and energy-saving capabilities, these models are perfect choices for those aiming to achieve superior climate comfort while being environmentally conscious. Whether you need a system for a small space or a larger area, Sanyo offers reliable solutions that cater to diverse cooling and heating needs.