Sanyo RCS-SH80UA.WL, RCS-SH1UA, RCS-BH80UA.WL instruction manual Heating performance Defrosting

Page 33

Heating Operation

Heating performance

Defrosting

(STANDBY) lamp on the indoor unit

ADDRESS switch setting

NOTENOTE

Special Remarks

Because this appliance heats a room by utilizing the heat of the outside air (heat pump system), the heating efficiency will fall off when the outdoor temperature is very low. If sufficient heat cannot be obtained with this heat pump, use another heating appliance in conjunction with this unit.

When the outdoor temperature is low, frost or ice may form on the outdoor heat exchanger coil, reducing the heating performance. When this happens, a microcomputer-controlled defrosting system operates. At the same time, the fan on the indoor unit stops (or runs at

very low speed in some cases) and the (STANDBY) lamp lights on the indoor unit until defrosting is completed. Heating operation then restarts after several minutes. (This interval will vary slightly depending upon the outdoor temperature and the way in which frost forms.)

For several minutes after the start of heating operation, the indoor fan will not start running (or it will run at very low speed in some cases) until the indoor heat exchanger coil has warmed up sufficiently. This is because a

cold draft prevention system is operating. During this period, the (STANDBY) lamp remains lit.

(STANDBY) lamp remains lit during defrosting or when the compressor has been turned off (or when the unit is running at very low speed) by the thermostat when the system is in the heating mode.

Upon completion of defrosting and when the compressor is turned on

again, (STANDBY) lamp will light off automatically as the heating operation resumes.

When setting up two or three air conditioners in one room, you can control the air conditioners correctly by setting the ADDRESS switches of the Operation Controllers and the Wireless Remote Controllers.

You can control the air conditioners:

1) with one wireless remote controller changing the ADDRESS switch setting

2

 

of the wireless remote controller.

 

2)with each wireless remote controller having the ADDRESS switch set differently.

Should the power fail while the unit is running

If the power supply for this unit is temporarily interrupted the unit will automatically resume operation (once the power is restored) with the same settings that were in effect before the power was interrupted.

Be sure to place the wireless remote controller where it can operate the air conditioner correctly.

2 - 15

Image 33
Contents RCS-SH1UA RCS-SH80UG Contents Installation Location Type 4-WAY Celling panel Optional Air outlet Air intake Wired typeType Air outlet Air intake Available for all Indoor unitsMode button SettingSET button ButtonTimer SET button Cool mode and dry mode, when the flaps are set in aOFF Timer OFF Cycle TimerRemote Control Unit Description Display Remote Control UnitSetting the fan speed Setting the modeSetting the temperature Setting the airflow directionCeiling mounted type T Auto flap Semi-concealed type Way typeVertical directions automatic Horizontal directions manualConcealed duct type U Wall mounted type K Vertical directions automaticSpecial Remarks OFF cycle TimerON Setting the TimerIndication OperationAir filter How to clean the filter Care and CleaningCleaning, be sure to attach the two bolt screws Safety chainRemove the air filter attached to the air intake grille LatchTrouble Possible Cause Remedy Should the power fail while the unit is runningRCS-SH80UA.WL RCS-BH80UA.WL RCS-SH1UA Product Information ContentsInstallation Location Safety InstructionsElectrical Requirements Lamp Operation lamp Remote control receiverStandby lamp Operation controllerAddress switch SwitchServicing switches Sweep buttonAutomatically Direction marked in the battery compartment How to Install BatteriesTime, on time, and OFF time are all reset to Direction of the arrowPlace 1here Press Installation fitting of wireless remote control unitSetting buttons TemperatureRemote Cotrol Unit Only for heat pump typeOFF Cycle Timer OFF TimerVent Do not move the flap with your hands SET buttonALL Clear Description IndicationSetting the temperature Setting the fan speedSetting the airflow direction To start the air conditionerPress the ON/OFF operation button again Operation without the Wireless Remote ControllerHeating performance Defrosting Should the power fail while the unit is runningTimer Setting the TimerOn timer OFF cycleOperation How to set the OFF timer2Tips for Energy Saving TroubleshootingTrouble Possible Cause Remedy Obstructed, the unit will not work well, and may be damagedSHA-KC64UG Alert Symbols Installation Location ALL/ZONE/GR How to Use the System ControllerFunctions of buttons On button Cool mode and dry mode, when the flaps are set in aOFF button FAN Speed buttonDo not use the SET button for normal operation FollowsDisplay Description How to start group operation Stop PowerStop Set the operation mode by pressing the Mode button How to start collective operationPage Page Sanyo Fisher Company

RCS-BH80UA.WL, RCS-SH80UA.WL, RCS-SH1UA specifications

Sanyo, a renowned brand known for its innovative heating and cooling solutions, offers a robust lineup of air conditioning systems, notably the models RCS-SH1UA, RCS-SH80UA.WL, and RCS-BH80UA.WL. These models are designed to provide efficient climate control solutions for both residential and commercial applications, emphasizing energy efficiency, comfort, and advanced technology.

The Sanyo RCS-SH1UA is a standout unit equipped with powerful heating and cooling capabilities ideal for varied environments. This compact split system offers a sleek design, making it suitable for small spaces while delivering substantial HVAC performance. One of its significant features is the advanced inverter technology, which adjusts the power consumption based on the current heating or cooling demand, ensuring consistent comfort and energy savings.

On the other hand, the RCS-SH80UA.WL and RCS-BH80UA.WL models are equipped with advanced features to enhance user experience. Both units boast high energy efficiency ratings, which are crucial for reducing electricity bills while minimizing environmental impact. These models incorporate innovative airflow systems that ensure uniform air distribution, creating a pleasant indoor environment regardless of outside conditions.

Both RCS-SH80UA.WL and RCS-BH80UA.WL are designed with user-friendly controls. The inclusion of remote control options allows for convenient adjustments without needing to be near the unit. Additionally, the air conditioning units come with programmable timers and multiple fan speeds, enabling users to fine-tune their climate control experience.

Another noteworthy characteristic across these Sanyo models is their whisper-quiet operation. Designed to minimize noise, they provide a tranquil atmosphere, making them suitable for bedrooms, offices, and other quiet spaces. Furthermore, the air-purifying technologies integrated into these units enhance indoor air quality by reducing pollutants and allergens, promoting a healthier living environment.

In conclusion, the Sanyo RCS-SH1UA, RCS-SH80UA.WL, and RCS-BH80UA.WL air conditioning systems symbolize a blend of efficiency, technology, and user-centric design. With their advanced features and energy-saving capabilities, these models are perfect choices for those aiming to achieve superior climate comfort while being environmentally conscious. Whether you need a system for a small space or a larger area, Sanyo offers reliable solutions that cater to diverse cooling and heating needs.