Sanyo RCS-BH80UA.WL, RCS-SH80UA.WL, RCS-SH1UA instruction manual ALL Clear

Page 29

 

Remote Control Unit (continued)

O: SENSOR button

Use this button to switch to the temperature sensor of the remote

 

controller.

 

The temperature sensor of the air-conditioner is selected at the factory

and the display indicates under this selection.

 

NOTENO

If the remote controller is located near a heat source, such as a space

 

 

heater or in direct sunlight, press the SENSOR button to switch to the

 

 

 

 

sensor on the indoor unit.

 

 

 

P: ACL button

Puts the wireless remote controller into pre-operation status. Always

(ALL CLEAR)

press this button after replacing the batteries.

 

 

 

Q: DISPLAY

Information on the operating conditions is displayed while the wireless

 

 

remote controller is switched on. If the unit is turned off, only the mode

 

 

that was set previously is still displayed.

NOTENOTE • The wireless remote controller sends the temperature signal to the air conditioner regularly at three minute intervals. If the signal from the wireless remote controller stops for more than ten minutes due to the loss of the wireless remote controller or other trouble, the air conditioner will switch to the temperature sensor which is built into the indoor unit and control the room temperature. In these cases, the temperature around the wireless remote controller may differ from the temperature detected at the air conditioner’s position.

DIP switch settings when the wireless remote controller will be used for cooling only

If the wireless remote controller will be used for cooling only, refer to the figure below and move the switch to position C.

Check that sliding switch 1 is set to “S.”

SKN

S:Flap type with limit switch

(4-way, ceiling-mounted, wall-mounted)

K:Swing-only type (floor-mounted) installed

N:No-flap type (built-in)

Set sliding switch 2 to match the unit type.

AHC AHC

A:Heat-pump type (H: Heat pump with

no auto heat/cool) C: Cool-only type

Sliding switch 1

ACL (ALL CLEAR) button

Sensor button

2

Sliding switch 2

2 - 11

Image 29
Contents RCS-SH1UA RCS-SH80UG Contents Installation Location Type 4-WAY Celling panel Optional Air outlet Air intake Wired typeType Air outlet Air intake Available for all Indoor unitsMode button SettingSET button ButtonTimer SET button Cool mode and dry mode, when the flaps are set in aOFF Timer OFF Cycle TimerRemote Control Unit Description Display Remote Control UnitSetting the fan speed Setting the modeSetting the temperature Setting the airflow directionCeiling mounted type T Auto flap Semi-concealed type Way typeVertical directions automatic Horizontal directions manualConcealed duct type U Wall mounted type K Vertical directions automaticSpecial Remarks OFF cycle TimerON Setting the TimerIndication OperationAir filter How to clean the filter Care and CleaningCleaning, be sure to attach the two bolt screws Safety chainRemove the air filter attached to the air intake grille LatchTrouble Possible Cause Remedy Should the power fail while the unit is runningRCS-SH80UA.WL RCS-BH80UA.WL RCS-SH1UA Product Information ContentsElectrical Requirements Installation LocationSafety Instructions Lamp Operation lamp Remote control receiverStandby lamp Operation controllerAddress switch SwitchServicing switches Sweep buttonAutomatically Direction marked in the battery compartment How to Install BatteriesTime, on time, and OFF time are all reset to Direction of the arrowPlace 1here Press Installation fitting of wireless remote control unitSetting buttons TemperatureRemote Cotrol Unit Only for heat pump typeOFF Cycle Timer OFF TimerVent Do not move the flap with your hands SET buttonALL Clear Description IndicationSetting the temperature Setting the fan speedSetting the airflow direction To start the air conditionerPress the ON/OFF operation button again Operation without the Wireless Remote ControllerHeating performance Defrosting Should the power fail while the unit is runningTimer Setting the TimerOn timer OFF cycleOperation How to set the OFF timer2Tips for Energy Saving TroubleshootingTrouble Possible Cause Remedy Obstructed, the unit will not work well, and may be damagedSHA-KC64UG Alert Symbols Installation Location ALL/ZONE/GR How to Use the System ControllerFunctions of buttons On button Cool mode and dry mode, when the flaps are set in aOFF button FAN Speed buttonDo not use the SET button for normal operation FollowsDisplay Description Stop How to start group operationStop Power Set the operation mode by pressing the Mode button How to start collective operationPage Page Sanyo Fisher Company

RCS-BH80UA.WL, RCS-SH80UA.WL, RCS-SH1UA specifications

Sanyo, a renowned brand known for its innovative heating and cooling solutions, offers a robust lineup of air conditioning systems, notably the models RCS-SH1UA, RCS-SH80UA.WL, and RCS-BH80UA.WL. These models are designed to provide efficient climate control solutions for both residential and commercial applications, emphasizing energy efficiency, comfort, and advanced technology.

The Sanyo RCS-SH1UA is a standout unit equipped with powerful heating and cooling capabilities ideal for varied environments. This compact split system offers a sleek design, making it suitable for small spaces while delivering substantial HVAC performance. One of its significant features is the advanced inverter technology, which adjusts the power consumption based on the current heating or cooling demand, ensuring consistent comfort and energy savings.

On the other hand, the RCS-SH80UA.WL and RCS-BH80UA.WL models are equipped with advanced features to enhance user experience. Both units boast high energy efficiency ratings, which are crucial for reducing electricity bills while minimizing environmental impact. These models incorporate innovative airflow systems that ensure uniform air distribution, creating a pleasant indoor environment regardless of outside conditions.

Both RCS-SH80UA.WL and RCS-BH80UA.WL are designed with user-friendly controls. The inclusion of remote control options allows for convenient adjustments without needing to be near the unit. Additionally, the air conditioning units come with programmable timers and multiple fan speeds, enabling users to fine-tune their climate control experience.

Another noteworthy characteristic across these Sanyo models is their whisper-quiet operation. Designed to minimize noise, they provide a tranquil atmosphere, making them suitable for bedrooms, offices, and other quiet spaces. Furthermore, the air-purifying technologies integrated into these units enhance indoor air quality by reducing pollutants and allergens, promoting a healthier living environment.

In conclusion, the Sanyo RCS-SH1UA, RCS-SH80UA.WL, and RCS-BH80UA.WL air conditioning systems symbolize a blend of efficiency, technology, and user-centric design. With their advanced features and energy-saving capabilities, these models are perfect choices for those aiming to achieve superior climate comfort while being environmentally conscious. Whether you need a system for a small space or a larger area, Sanyo offers reliable solutions that cater to diverse cooling and heating needs.