Sanyo RCS-SH80UA.WL, RCS-SH1UA, RCS-BH80UA.WL instruction manual Indication, Description

How to set the ADDRESS ( )

Setting addresses of indoor units for remote controller Operation

1.Press the ADDRESS button for more than four seconds.

2.By each pressing the ADDRESS button, the indicated address will

change from “ALL” to “1” through “6” in turn and lap to “ALL”. Adjust the address switch of an indoor unit you want to operate to match its address with the address indicated on the remote controller.

3. Press the SET button.

Indication

The display of the remote

controller indicates , and the current address appears and blinks.

The indicated address stops blinking and remains for five seconds.

NOTETE • If the set address on the remote controller matches with the controller address in an indoor unit, the buzzer will beep.

Address indication on the remote controller

Setting of the address switch of the controller in an indoor unit

Match this address with the address indicated on the remote controller.

If the remote controller indicates “ALL”:

You can set any address in the controller.

If the remote controller indicates “1”:

If the remote controller indicates “2”:

If the remote controller indicates “6”:

NOTE • To set the address to 1, 2, or 3, switch this “SWITCH” knob to the left;

SWITCH

to set the address to 4, 5, or 6, switch this “SWITCH” knob to the right.

E

2

B

Display

A

(Wireless Remote Controller)

D

C

Description

A:When you press the SENSOR button, the (SENSOR) indicator appears or disappears.

B:The currently selected operation mode is displayed.

C:When setting the timer, the selected timer mode is displayed.

D:The currently selected FAN SPEED, FLAP ANGLE and SWEEP status are displayed.

E:This indicator flashes when you operate the wireless remote controller.

2 - 12