Makita BFL201F specifications 30 to 50N.m

P 4/ 13

Repair

[3] DISASSEMBLY/ASSEMBLY

[3] -2. Spindle A complete section (cont.)

ASSEMBLING

1)Apply Makita grease N.No.2 to O ring 14. (Fig. 1)

Assemble O ring 14, Flat washer 14 then Spindle complete to Bearing retainer 14-23 as illustrated in Fig. 10.

Note: If you cannot assemble Spindle complete to Bearing retainer 14-23 by hand, do it using arbor press as illustrated in Fig. 11.

2)Apply about 2g of Makita grease N.No.2 to the Gear room of Angle head complete. (Fig. 1) Note: Be careful not to put Makita grease N.No.2 on the threaded portion of Angle head complete.

3)Apply Loctite 603 to the threaded portion of Bearing retainer 14-23. (Fig. 1) Then assemble Flat washer 6 to Spindle complete. (Refer to Fig. 8.) Assembling of Spindle complete section has been completed.

4)Clamp the flats of Angle head complete securely in a vise to which 1 set of 1R041 is attached, then assemble Spindle A complete section to Angle head complete by turning Bearing retainer 14-23 counterclockwise using 1R219, 1R220, 1R222 and 134861-3 as illustrated in Fig. 11.

Caution: When clamping Angle head complete, be very careful not to deform it by overtightening.

Fig. 10

Spindle A complete

Flat washer 14 O ring 14

Bearing retainer 14-23

Fig. 11

1R220	1R219
1R222
134861-3	Recommended tightening torque:
	30 to 50N.m
1R041