Makita BFL201F specifications Spiral bevel gear 9 section, Correct Wrong

P 5/ 13

Repair

[3]DISASSEMBLY/ASSEMBLY

[3]-3. Spiral bevel gear 9 section

DISASSEMBLING

1)Remove Light cover by unscrewing two M4x8 Pan head screws, then remove Switch lever and Compression spring 2. (Fig. 12)

2)Remove Angle head complete from Housing by unscrewing four M4x22 (+) Pan head screws, then remove Clutch section (= Clutch assembly) from Angle head complete. (Fig. 13)

Note: Be careful not to lose Compression spring 5, which may pop out from Clutch section when Clutch section is removed from Angle head complete. (Fig. 13)

Fig. 12 Fig. 13

Angle head complete	Housing	M4x22 (+) Pan head screws (4pcs.)
	Switch lever	Clutch section
		(= Clutch assembly)
	Compression spring 2
	Light cover	Compression spring 5

3) Using 1R173, remove Retaining ring R-22 Fig. 14		Fig. 15
that retains Spiral bevel gear 9 section in	1R173	Spiral bevel
		gear 9 section
Angle head complete. (Fig. 14)
Spiral bevel gear 9 section can now be
removed by tapping the end surface of
Angle head complete with plastic
hammer. (Fig. 15)	Retaining ring R-22

4)Remove Retaining ring S-10 using 1R291, then remove Ball bearing 6900LLB using 1R269. Spacer and Needle bearing 1210 can now be removed from Spiral bevel gear 9. (Fig. 16)

Fig. 16

Retaining ring S-10	1R291	Ball bearing 6900LLB		Spacer
		1R269	Needle baring 1210
			Spiral bevel gear 9
ASSEMBLING

Do the reverse of the disassembling steps. (Refer to Figs. 16 to 12.) Note 1: Spacer is not reversible when assembled to Spiral bevel gear 9.

Be sure to assemble as illustrated to left in Fig. 17.

Note 2: Use 1R034 and arbor press when assembling Ball bearing 6900LLB to Spiral bevel gear 9. (Fig. 18)

Fig. 17 Fig. 18

[Correct]	[Wrong]
Needle baring 1210	Spacer
Spiral bevel gear 9

Arbor press

Spiral bevel gear 9 Needle baring 1210 Spacer

Ball bearing 6900 LLB 1R034