Chicago Pneumatic SD25 user manual Attaching a Pistol Grip Handle

6159939020 SD25 Series Screwdrivers

Use the following procedure to attach a Pistol Grip handle (part number 49-SD-10111) to an In-line screwdriver. Refer to Viewing Screwdriver Functions on page 7 to view an illustration of the In-line screwdriver that may help you with this procedure.

Attaching a Pistol Grip Handle

1.Remove the screwdriver-to-controller cable, if necessary.

2.Using a 5/32-in punch, hammer out the pin that attaches the throttle/trigger lever to the In-line screwdriver.

3.Remove the throttle/trigger lever spring. It may fall out when you remove the throttle/trigger lever so be prepared to catch it.

NOTE:

?

Put the throttle/trigger lever and spring into a safe place. If, in the future, you remove the handle attachment, you will need the throttle/trigger lever and spring to convert the screwdriver back to the In-line model.

4.Carefully slide the In-line screwdriver into the handle attachment with the forward/reverse and multi-purpose (auxiliary) buttons positioned on the top.

5.Position the handle on the bottom of the screwdriver, on the side of the screwdriver opposite to the forward/reverse and multi-purpose (auxiliary) buttons.

6.Slide the pin back into the handle attachment.

You will need to hammer it carefully back into place. Make sure the screwdriver does not rotate or move in relation to the position of the handle during this process.

7.Using a 5/32-in Allen wrench, tighten the fastener on the handle attachment until it is secure.

You are now ready to use your Pistol Grip screwdriver.

Page 14 39-30-40409