6159939020 SD25 Series Screwdrivers
Mapping Outputs for a Single-Spindle
Typically, the LEDs and headlights on the screwdriver work in the following way:
•Headlights turn on while the screwdriver is running in forward or reverse.
NOTE: | Yellow, green and red LEDs chase each other in a |
? | counterclockwise direction while the screwdriver is in reverse. |
|
• Green LEDs turn on to indicate a successful cycle completion achieving target torque/angle within acceptable range.
• Yellow LEDs turn on to indicate lower than acceptable torque/angle.
• Red LEDs turn on to indicate higher than acceptable torque/angle.
The screwdriver outputs are software selectable using VS. To operate the screwdriver as a single- spindle tool, assign the Cycle Good output to Output 2, Cycle Bad output to Output 3, Output 8 (Timed Copy) to Output 7 and the Ready output to Output 8. The typical outputs for operating the screwdriver as a
NOTE: The time delay for Output 8 (Timed Copy) can be adjusted ? using the Timers tab in VS. For details, refer to the Visual
Supervisor User’s Guide (part number 39-30-34823).
Page 18 |