Sanyo KHS3682, KHS3082 Using the Remote Control Unit, ACL button, 16 mm, Included

Page 8

01_KHS3682_EN.fm Page 8 Friday, February 12, 2010 12:42 PM

USING THE REMOTE CONTROL UNIT

HOW TO INSTALL BATTERIES

ACL button

1.Slide the cover in the direction indicated by the arrow and remove it.

2.Install two AAA alkaline batteries. Make sure the batteries point in the direction marked in the battery compartment.

3.Use a thin object such as the tip of a pen to press the ACL button.

NOTE

The batteries last about six months, depending on how much you use the remote control unit. Replace the batteries when the remote control unit’s display fails to light, or when the remote control unit cannot be used to change the air conditioner’s settings.

Use two fresh leak-proof type-AAA alkaline batteries.

In replacing batteries, follow the instructions as mentioned in the sub-section “HOW TO INSTALL BATTERIES”.

If you do not use the remote control unit more than 1 month, take out the batteries.

Dispose of the used batteries at the designated location in compliance with the applicable local ordinances.

HOW TO USE THE REMOTE CONTROL UNIT

When using the remote control unit, always point the unit’s transmitter head directly at the air conditioner’s receiver.

Air conditioner (Indoor unit)

Receiver

Remote control unit

(Transmitter head)

 

REMOTE CONTROL UNIT INSTALLATION POSITION

The remote control unit may be operated either from a non-fixed position or from a wall-mounted position. To ensure that the air conditioner operates correctly, DO NOT install the remote control unit in the following places:

DO NOT

In direct sunlight

Behind a curtain or other places where it is covered

More than 26 ft.(8 m) away from the air conditioner

In the path of the air conditioner’s airstream

Where it may become extremely hot or cold

Where it may be subject to electrical or magnetic noise

Where there is an obstacle between the remote control unit and air conditioner (since a check signal is sent from the remote control unit every 5 minutes)

MOUNTING THE REMOTE CONTROL UNIT

Before mounting the remote control unit, press the ON/OFF operation button at the mounting location to make sure that the air conditioner operates from that location. The indoor unit should make a beeping sound to indicate that it has received the signal.

Rear side

Remote control unit mount

 

Press

 

 

Set in

Hole

 

place

 

 

Mounting screws

 

 

5/32 x 5/8"

• To prevent loss of the remote control

(4 x 16 mm)

unit, you can connect the remote

(included)

control unit to the mount by passing

a string through the remote control unit and attachment hole.

To take out the remote control unit, pull it forward.

WHEN HOLDING THE REMOTE CONTROL UNIT

When using the remote control unit and during air conditioner operation, the transmitter on the remote control unit should be pointed towards the receiver on the indoor unit.

Make sure that there are no objects between the remote control unit and receiver which could block the signal.

8

OI-149-8-EG

 

Image 8
Contents Mode D’EMPLOI KHS3082 KHS3682Features ContentsAlert Symbols Installation LocationSafety Instructions Product InformationNames of Parts Unit Display and Operation ButtonRemote Control Unit Display SymbolsRemote Control Unit HR. Timer button 1-HOUR OFF Timer Temperature setting buttons TempMode selector button High Power buttonUsing the Remote Control Unit Air conditioner Indoor unit Receiver Remote control unitACL button 16 mmOperation with the Remote Control Unit Automatic OperationManual Operation StepAdjusting the Fan Speed Night Setback ModeQuiet Mode Fan OnlyHigh Power Mode LED Clean ModeUnoccupied Mode Unoccupied Indication StatusSpecial Remarks Setting the Timer How to set the present timeHow to set the OFF time How to set the on timeUsing the 1-HOUR OFF Timer How to set daily ON/OFF repeat timerHour OFF Timer Operation together with the daily ON/OFF repeat timerAdjusting the Airflow Direction Operation Without the Remote Control UnitCare and Cleaning HorizontalAir Clean Filter How to install the air clean filterHow to clean the air clean filter Cleaning the main unit and remote control unitTroubleshooting Wired Remote ControllerOperating Range Washing the front panel with waterCaractéristiques Table DES MatièresSymboles ’AVERTISSEMENT Emplacement D’INSTALLATIONInformations SUR LE Produit Conseils DE SécuritéNOM DES Pièces Télécommande Affichage SymbolesTélécommande Bouton de temporisateur 1 heure 1 HR. Timer Sélecteur de mode ModeBouton de haute puissance High Power CapteurUtilisation DE LA Télécommande Climatiseur élément intérieur Récepteur TélécommandeBouton ACL 32 x 5/8 4 x 16 mmFonctionnement Avec Télécommande Fonctionnement automatiqueFonctionnement manuel ÉtapeMode économie nocturne Mode de silencieux QuietRéglage de la vitesse du ventilateur Vitesse manuelle du ventilateurMode de fonctionnement à haute puissance Mode de voyant de nettoyage LED CleanMode Pièce inoccupée Unoccupied Indication de pièce inoccupéeRemarques Spéciales Réglage DU Temporisateur Réglage à l’heure actuelleRéglage du moment de mise à l’arrêt Réglage du moment de mise en marcheTemporisateur 1 heure 1 Hour OFF Timer Emploi DU Temporisateur 1 HeureConseils Pour Économiser L’ÉNERGIE Choses à ne pas faireFonctionnement Sans Télécommande Réglage DU Flux D’AIREntretien ET Nettoyage HorizontalementInstallation du filtre de nettoyage d’air Remplacement du filtre anti-moisissureNettoyage de l’appareil principale et de la télécommande Filtre anti-moisissureTélécommande Filaire Guide DE DépannagePlage DE Températures DE Fonctionnement Nettoyage du panneau avant à l’eauIshida Make up USレター 白ページ Ishida Make up USレター 白ページ Sanyo Ave., San Diego

KHS3082, KHS3682 specifications

Sanyo holds a significant position in the realm of home appliances, particularly with its innovative and efficient refrigerator models such as the KHS3682 and KHS3082. These two models stand out for their combination of advanced technology and user-friendly features, making them ideal choices for modern households.

The Sanyo KHS3682 is a top-of-the-line refrigerator characterized by its spacious interior and cutting-edge design. This model features a remarkable cooling system that employs direct cooling technology, ensuring uniform temperature distribution throughout the fridge. With a total capacity of approximately 368 liters, it provides ample space for storing fresh produce, beverages, and frozen goods, making it perfect for families and individuals alike.

One of the key features of the KHS3682 is its energy efficiency. It is equipped with an inverter compressor that adjusts its speed based on the cooling demand. This technology not only helps to reduce electricity consumption but also minimizes noise levels, providing a quieter environment. Furthermore, the model is designed with a frost-free interior, eliminating the need for manual defrosting and ensuring that food stays fresh for extended periods.

On the other hand, the Sanyo KHS3082 offers similar qualities but caters to slightly smaller needs, with a capacity of around 308 liters. This model also boasts an advanced cooling system enhanced by the direct cooling technology. An affordable alternative, the KHS3082 is designed to suit those who may not require a larger refrigerator but still desire efficiency and quality.

Both models feature adjustable shelving, allowing users to customize their storage according to their preferences and requirements. The bright LED lighting adds visibility throughout the fridge, making it easy to locate items. Additionally, the humidity-controlled crisper drawers are designed to keep fruits and vegetables fresher for longer periods, reducing food waste.

In terms of design, both the KHS3682 and KHS3082 come with sleek exteriors available in various finishes, making them suitable for any kitchen décor. Their designs incorporate ergonomic handles and easy-to-clean surfaces, enhancing user convenience.

In summary, the Sanyo KHS3682 and KHS3082 refrigerators deliver on technology, efficiency, and design. With features like inverter compressors, adjustable shelving, and frost-free interiors, these models are robust solutions for anyone seeking reliable refrigeration in modern living spaces.