Makita 5093DZ instruction manual Important Safety Instructions For Charger Battery Cartridge

Page 9

IMPORTANT SAFETY INSTRUCTIONS

FOR CHARGER &

BATTERY CARTRIDGE

1.SAVE THESE INSTRUCTIONS - This manual

contains important safety and operating instructions for battery charger.

2.Before using battery charger, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery.

3 . CAUTION - To reduce risk of injury, charge only MAKITA Battery Cartridge 7000, 7001, 7002, 7033, 7100, 7120, 9000, 9001, 9002, 9033, 9100,

9101,9102,9120,9122,9133,1200,1201,1202,1210,1211,1220,1222,

I233,1422,1433,9101A, 9102A. 1201A or 1202A. Other types of batteries may burst causing personal injury and damage.

4.Do not expose charger t o rain or snow.

5.Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock, or injury t o persons.

6.To reduce risk of damage t o electric plug and cord, pull by plug rather than cord when disconnecting charger.

7.Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected t o damage or stress.

8.A n extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure:

a.That pins on plug of extension cord are the same number, size, and shape as those of plug on charger;

b.That extension cord is properly wired and in good electrical condition; and

c.That wire size is at least as large as the one specified in the table below.

TABLE 1

RECOMMENDED MINIMUM AWG SIZE FOR

EXTENSION CORDS FOR BATTERY CHARGERS

I Length of Cord (Feet) I

2 5 I

5 0

I 100 I 1 5 0 I

1

 

I

 

 

 

 

 

I

I

AWG Size of Cord

18 I

18

II

18

I 16

 

I

I

 

I

I

 

 

 

 

 

9. Do not operate charger with damaged cord or plug - replace them im- mediately.

I O . Do not operate charger if it has received a sharp blow, been dropped, or other- wise damaged in any way; take it to a qualified serviceman.

11.Do not disassemble charger or battery cartridge; take it t o a qualified serviceman when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire.

12. To reduce risk of electric shock, unplug charger from outlet before attempt- ing any maintenance or cleaning. Turning off controls will not reduce this risk.

9

Image 9
Contents RPM Work Area General Safety RulesTool Use and Care ServiceSpecific Safety Rules Causes and Operator Prevention of Kickback Kickback Dont TRY to Hold Short Places by Hand Min Hens9101,9102,9120,9122,9133,1200,1201,1202,1210,1211,1220,1222 Important Safety Instructions For Charger Battery CartridgeAdditional Safety Rules For Charger & Battery Cartridge Installing the set plate Installing or removing the battery cartridgeCharging Hex wrench storage Removing or installingthe saw bladeBevel cutting Adjusting the depth of cutSwitch action SightingOperation Trickle charge Maintenancecharge Tips for maintainingmaximum battery lifeGuide rule Recycling the Battery Accessories 85 mm 3-3/8 Makita Corporation of America