PIVOTING GUIDE SHOE FEATURES
1.Model 745 is supplied with a standard hex key guide shoe.
2.Models 746 and 747 are supplied with a keyless
ADJUSTING PIVOTING GUIDE SHOE
DISCONNECT TOOL FROM POWER SOURCE.
DO NOT OPERATE THE TIGER SAW® WITH THE GUIDE SHOE REMOVED.
The pivoting guide shoe (A) Fig. 12, serves as a rest while making a cut and it can be adjusted to accommodate many types of cutting applications.
A
Fig. 12
1.The Model 745 pivoting guide shoe is adjusted by loosening the two hex screws (with wrench supplied) located on the bottom of the front gear housing (A) Fig. 12A. Loosen both screws enough to allow the pivoting guide shoe to move freely. Adjust to desired position and securely tighten both screws.
NOTE: Do not adjust the pivoting guide shoe out so far that it loses contact with the back screw. Doing so will cause the guide shoe to be unstable.
After adjusting, make sure both screws are securely fastened.
A
Fig. 12A
14