PYLE Audio 747 Troubleshooting Maintenance, Sawing Metal, Keep Tool Clean, Failure to Start

Page 16

Fig. 13

Fig. 14

SAWING METAL

When cutting angle, H-beam, I-beam, channel, etc., start the cut on the surface where the greatest number of teeth will contact the work. To make a pocket cut, drill a starting hole first. To extend blade life, cutting oil can be applied to the work surface along the line of the cut.

TROUBLESHOOTING

For assistance with your tool, visit our website at www.porter-cable.com for a list of service centers or call the Porter-Cable help line at 1-800-487-8665.

MAINTENANCE

KEEP TOOL CLEAN

Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp cloth. NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the material.

Wear ANSI Z87.1 safety glasses while using compressed air.

FAILURE TO START

Should your tool fail to start, check to make sure the prongs on the cord plug are making good contact in the outlet. Also, check for blown fuses or open circuit breakers in the line.

LUBRICATION

This tool has been lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal operating conditions. No further lubrication is necessary.

BRUSH INSPECTION (If applicable)

For your continued safety and electrical protection, brush inspection and replacement on this tool should ONLY be performed by an AUTHORIZED PORTER-CABLE SERVICE STATION or a PORTER-CABLE•DELTA FACTORY SERVICE CENTER.

At approximately 100 hours of use, take or send your tool to your nearest authorized Porter-Cable Service Station to be thoroughly cleaned and inspected. Have worn parts replaced and lubricated with fresh lubricant. Have new brushes

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Double Insulated Variable Speed Tiger SAW All-Purpose Saws Table of Contents Important Safety InstructionsSafety Guidelines Definitions California PropositionGeneral Safety Rules General Safety Rules Additional Specific Safety Rules Symbol Definition MotorCarton Contents AssemblyFunctional Description Extension Cord SelectionBlade Clamp Features Installing the Blade ModelOperation Selecting the BladeWear Ansi Z87.1 Safety Glasses While Using Compressed AIR Handle Features HOW to Hold SAW Model 745To Start and Stop SAW Variable Speed Dual Blade Motion Model 747 onlyPivoting Guide Shoe Features Adjusting Pivoting Guide ShoeSawing Wood Before YOU Start to WorkPlunge Cuts Troubleshooting Maintenance Keep Tool CleanSawing Metal Failure to StartAccessories ServiceReplacement Parts Service and Repairs PORTER-CABLE Limited ONE Year Warranty Canadian PORTER-CABLE Delta Service Centers
Top Page Image Contents