PYLE Audio 747 instruction manual Motor, Symbol Definition

SYMBOL	DEFINITION
V	volts
A	amperes
Hz	hertz
W	watts
kW	kilowatts
F	farads
µF	microfarads
l	litres
g	grams
kg	kilograms
bar	bars
Pa	pascals
h	hours
min	minutes
s	seconds
n0	no-load speed
…/min or …min-1	Revolutions or reciprocations per minute
or d.c	direct current
or a.c	alternating current
2	two-phase alternating current
2N	two-phase alternating current with neutral
3	three-phase alternating current
3N	three-phase alternating current with neutral
........................	rated current of the appropriate fuse-link in amperes
........................	time-lag miniature fuse-link where X is the symbol
	for the time/current characteristic, as given in IEC 60127
........................	protective earth
........................	class II tool
IPXX	IP symbol

MOTOR

Many Porter-Cable tools will operate on either D.C., or single phase 25 to 60 cycle A.C. current and voltage within plus or minus 5 percent of that shown on the specification plate on the tool. Several models, however, are designed for A.C. current only. Refer to the specification plate on your tool for proper voltage and current rating.

Do not operate your tool on a current on which the voltage is not within correct limits. Do not operate tools rated A.C. only on D.C. current. To do so may seriously damage the tool.

7