5.Front Handle (3G): Use to securely hold the Cut Off Saw when operating.
6.Spark Plug Cover (4D): A removable cover for access to the Spark Plug (2B).
7.Kill Switch (5D): Engine stops when this switch is pressed and held.
8.Full Throttle Lock Button (9D): To lock the Throttle Trigger (10D) in wide open position, press this button while the Throttle Trigger is fully depressed. Pressing and releasing the Throttle Trigger will return the Throttle Trigger to its idle position.
9.Throttle Trigger (10D): Controls the Engine speed. Pulling back on the Throttle Trigger opens the throttle and the Engine accelerates. Releasing the Throttle Trig- ger slows down the Engine.
10.Rear Handle (7D): Use to securely hold the Cut Off Saw when operating.
11.Filter Cover Lock Lever (13E): Locks the Air Filter Cover (1E). Pull back on the Filter Cover Lock Lever to open the Air Filter Cover.
12.
13.Choke Lever (5C): Turning this Lever counterclockwise closes the Carburetor. Use the Choke Lever to prime the Engine (cold starting). Turn clockwise for normal operation.
14.Starter Grip (3A): Pull to start Engine.
15.Fuel Tank Cap (16C): Open this Cap for filling the Fuel Tank (2C, 10C). Close the Fuel Tank Cap prior to for starting and operation.
16.Decompression Valve (7B): Press down on this Valve to make starting easier. When air pressure in the Engine reaches a preset value, the Valve automatically closes.
17.Belt Tensioner with Tensioning Nut (35F): For
18.Muffler (9B): Reduces both noise and emissions.
19.Blade Guard Positioning Knob (38F): Loosen the Knob to adjust the Blade Guard (19F) position.
20.Shaft Lock (34F): Press and hold the Shaft Lock to facilitate Saw Blade (23F) changing and installation.
REV 07e
SKU 94488 | For technical questions, please call | PAGE |