Unpacking and Cleaning

Your new scroll saw and stand is shipped complete in one container. Carefully unpack the saw, stand and all loose items from the shipping container. Figure 2 illustrates the saw and all loose items and Figure 3 illustrates the stand and all related parts. Remove the protective coating from the saw table surface. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone, gasoline or lacquer thinner for this purpose). After cleaning, cover the table surface with a good quality paste wax. Buff out the wax thoroughly to prevent it from rubbing into

your workpieces.

		1	11
		1	10
			10
			9
2	5		18
	5

3			7
4			6

Fig. 2

1 - Scroll Saw

2 - Holddown Foot

3 - 1/2" Long Hex Socket Head Screw - for fastening holddown foot to rod

4 - Lockwasher - for fastening holddown foot to rod

5 - Flat Washer - for fastening holddown foot to rod

6 - Table Insert

7 - 5mm Wrench

8 - 1-1/2" Long Hex Head Screws - for fas- tening front of saw to stand (2)

9 - Flat Washers - for fastening front of saw to stand (4)

10 - Lockwashers - for fastening front of saw to stand (2)

11 - Hex Nuts - for fastening front of saw to stand (2)

12 - 5/8" Long Hex Head Screws - for fasten- ing rear of saw to stand (2)

13 - Lockwashers - for fastening rear of saw to stand (2)

14 - Flat washers - for fastening rear of saw to stand (2)