Delta 40-650 Type 2 instruction manual Fastening Scroll SAW To Stand

FASTENING SCROLL SAW

TO STAND

1.Place scroll saw on top braces of stand and fasten front of saw to top front brace using the two 1-1/2" long screws (A) Fig. 5, flat washers (B) and two flat washers (C), lock washers (D) and hex nuts (E) from below.

2.Fasten the rear of the saw to the stand using the two

5/8" long screws (F) Fig. 6, and lock washers

(G). The 5/8" long screws (F) are also shown in Fig. 7, and are threaded up into the threaded holes located on bottom of saw base.

A

BC

D E

A

B

Fig. 5

G

F

Fig. 6

F

F

3.Figure 8 illustrates the saw (H) fastened to the stand (J). Place the stand on a level sur- face and securely tighten all stand mounting hardware.

Fig. 7

H

J

Fig. 8

7