ASSEMBLING REAR LEG
HEIGHT EXTENSION
1.A height extension (A) Fig. 9, is supplied with your stand and can be assembled to the rear leg of the stand, as shown, using the four carriage bolts (B), flat washers and nuts sup- plied. The height extension enables you to tilt the saw forward during operation if desired. Five holes are supplied in the extension (A) to vary the degree of tilt.
ASSEMBLING
HOLDDOWN FOOT
1.With wrench supplied, assemble holddown foot (A) Fig. 10, to rod (B) using 1/2² hex sock- et head screw (C)
with lockwasher and flat washer. Prongs of holddown foot (A) should straddle blade.
2.Adjustment to holddown rod (B) Fig. 10,
can be made by loosening lock handle (D) and raising or lowering rod (B). Tighten lock handle
(D). NOTE: Lock handle (D) Fig.10, is spring- loaded and can be repositioned by pulling outward on the handle and repositioning it on the stud located underneath the hub of handle
(D).
ROTATING TABLE TO 90 DEGREE POSITION
1.The saw is shipped with the table tilted 45 degrees to the right, as shown in Fig. 11. To move the table to the 90 degree position, loosen lock handle (A) and rotate table all the way to the left. Then tighten lock handle (A). NOTE: Lock handle (A) is
2.Fig. 12 illustrates the table (B) in the 90 degree position.
ASSEMBLING TABLE INSERT
1.Assemble the table insert (C) Fig. 12, to opening in the center of the table (B) as shown.
8
B
A
Fig. 9
C | D |
A |
|
| B |
Fig. 10
A
Fig. 11
B
C
Fig. 12