SpecificationsFunctions
Electrical Requirements | 120 V~ / 60 Hz / 6.6A |
|
|
Motor Speed | n0 1,000/min |
Chuck Size | 1/2 Inch |
|
|
Chuck Type | Keyless |
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Instructions for putting into use
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
1.This
2.The Trigger can be locked in the ON position for extended operation.
3.The Keyless Chuck allows the op- erator to install and remove drill bits without the use of a separate key or other tool.
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
1.To insert a drill bit, hold the rear ring of the Chuck (2) with one hand while turning the front ring with the other.
Open the jaws enough to allow the bit to slide in. Turn the front ring the op- posite direction to tighten the jaws on the bit. Be sure the bit is centered in the jaws. Tighten firmly by hand.
SKU 97594 | For technical questions, please call | Page 9 |