Craftsman 973.111430 owner manual Batteries, Preparation for Recycling

Page 13

10103/01

WED 13:47

FAX 864 964 .3314 RYOBI CUSTOMER SERVICE

[_]014/015

part may create a hazard or cause product damage.

Avoid using solvents when cleaningplasticparts. Most plastice are susceptibleto damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust. oil, grease, etc.

oils, etc. come in contact with plasticpads. They contain chemicals that can damage, weaken or destroy plastic.

BATTERIES

Your'drill'sbattery pack is equipped with 14 nickel- cadmium rechargeable batteries. Length of service from each charging willdepend on the type of work you are doing.

The batteries in this tool have been designed to provide maximum trouble free life. However. like all batteries, they will eventually wear out. De not disassemble battery pack and attempt to replace the batteries. Handling of these batteries, espedally when

wearing rings and Jewelry,could result in _.serious burn.

To obtain the longest possible battery llte, we suggest the following:

To preservenatural resources, please recycleor disposeof batteries properly.

This productcontains nickel- cadmium batteries. Local, state or federal laws may prohibitdisposalof nickel-cadmium batteries In ordinary trash.

Consult your local waste authority for information regarding available recycling and/or disposal options.

Do not abuse power tools. Abusive practices can damage tool as well as Well,Oleos.

Only the parts shown on parts list, page 15, are intended to be repaired or replaced by the customer.

All other parts shouldbe replaced by a Sears Service

Center.

_k. cWrtReN/NeGsD° an:tn_tt;2c_Ptrot°emndc_fyftOhididJts_OIor

with this tool. Any such alteration or modification is misuse and could result in a hazardous

conditionleading to possible serious personal injury.

IIStore and charge your batteries in a cool ares. Temperatures above normal room temperature will shorten battery life.

[] Never store batteries in a discharged condition.

Recharge them Immediately after they are discharged.

[] All batteries gradually 10setheir charge. The higherthe temperature the quicker they lose their charge. If you store your tool for long perleds of time withoutusing it, recharge the batteries every month or two. This practicewill prolongbattery lile.

BA'I-rERY PACK REMOVAL AND

PREPARATION FOR RECYCLING

Do hot attempt to destroy or disassemble battery pack or remove any of its components. Nickel- cadmium batteries mustbe recycled or disposed of properly.Also, never touch both terminals with metal objectsand/or body parts as short c_rcuit may result. Keep away from children. Failure to comply with these warnings could result in fire and/or serious injury.

13

Image 13
Contents Model No III SpecificationsRead ALL Instructions Meaning Safety Alert SymbolImportant Safety Rules for Battery II Keep Handles DRY, CLEAN, and FreeII do not Place Battery Tools or Their Do not Charge Battery Tool in a Damp or WET LocationDo not Operate Charger with a See Fi#um See FumTo Charge Charging BAI-FERY PackSelector Variable Speed See FigureSos Figure To Remove Baitery PackLock Switch LockTrigger Keyless Chuck DrillbitSee Fi#ure Z See FTgure7Bitstoragearea BIT StorageLevel Drilling DrillingGee Figures f3, 14, Chuck RemovalCHUCK,JAWSHEXKEY Wrengh To Retighten a Loose ChuckPreparation for Recycling BatteriesSee Back page for Parts Ordering Instructions Parts List