Craftsman 973.111430 owner manual See FTgure7, See Fi#ure Z

Page 10

10103101 WED 13:46

FAX 864 964 3314 RYOBI CUSTOMER SERVICE

[_011/015

INSTALLING BITS

See FTgure7..

Lock the switch triggerby placingthe directionof rotation selector in center position.See Figure 5.

Open or close chuck jaws to a pointwhere the opening is slightly larger than the bit size you Intend to use. Also, raise the front of your drill slightly to keep the bit from faiUngout of the chuck Jaws.

Insert drill bit straight Into chuck the full length of the jaws as shown in Figure 7.

Tighten the chuck jaws on drillbit.

CHUCKBODY

CHUCKJAWS

DRILL BIT

CHUCKCOLLAR

PJGHT

Fig. 7

IN To tighten the chuck Jawson drillbit; grasp and hold the collar of the chuck with one hand, while rotating the chuck body with your other hand.

Note= Rotate the chuck body in the directionof the arrow marked LOCK to tighten chuck jaws,

Do not use a wrench to tighten or loosenthe chuck jaws.

jaws at an angle then tighten as shown in Figure 8, This could cause drillbit tO be thrownfrom ddn. resulting In possibleserious personalinjuryor damage to the chuck.

REMOVING BITS

See Fi#ure Z

Lock the switch trigger by placingthe directionof rotationselector in center position.See F/gur_ 5.

Loosenthe chuckjaws from drillbit.

II To loosen:grasp and hold the collar of the chuck

with one hand, while rotatingchuck body with your other hand. Note: Rotate chuck body in the directionof the arrow marked UNLOCK to loosen

chuck Jaws.

11Do not use a wrench to tighten or loosen the chuck jaws.

IIRemove drillbit frem chuck jaws.

ADJUSTABLE TORQUE CLUTCH

Your ddll is equipped with an adjustable torque oJutoh for driving different types of sorews intodifferent mate- dais. The proper settingdepends on the type of mate- dal and the size of screw you are using,

TO ADJUST TORQUE

Identify the twenty four torque indicator settings locatedon the front of your drill. See Figure 9.

Rotate adjusting ring to the desired setting,

1 - 4 For driving small screws.

5 - 8 For driving screws into soft material.

9 - 12 For driving screws intosoft and hard materials.

13 - 16 For driving screws in hard wood.

17 - 20 For ddving large screws.

21 - 4,_1,¶For heavy drill(rig.

TO DECREASE

TORQUE

_LDJUSTING

RING

TOINCREASE

TORQUE

Image 10
Contents Model No Specifications IIIMeaning Safety Alert Symbol Read ALL InstructionsII do not Place Battery Tools or Their II Keep Handles DRY, CLEAN, and FreeImportant Safety Rules for Battery Do not Charge Battery Tool in a Damp or WET LocationDo not Operate Charger with a See Fum See Fi#umCharging BAI-FERY Pack To ChargeSos Figure See FigureSelector Variable Speed To Remove Baitery PackTrigger Keyless Chuck Switch LockLock DrillbitSee FTgure7 See Fi#ure ZLevel Drilling BIT StorageBitstoragearea DrillingCHUCK,JAWSHEXKEY Wrengh Chuck RemovalGee Figures f3, 14, To Retighten a Loose ChuckBatteries Preparation for RecyclingParts List See Back page for Parts Ordering Instructions