10/03/01 | _ED 13:45 | FAX 864 964 3314 RYOBI ¢UST0_[ER SERVICE | _006/015 |
RULES FOR SAFE OPERATION (Continued)
•An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a dsk of fire and electric shock.
If extension cord must be used. make sure:
a. That pins on plug of extension cord are the
same number, size and shape as those of plug on charger.
b.That extension cord is propedy wired and in good electrical condition:and
c.That wire size is large enough for AC ampere rating of charger as specified below:
Cord Length {Feet) 25'50' f00'
Cord Size (AWG) 16 16 16
Note: AWG = American Wire Gage
•DO NOT OPERATE CHARGER WITH A
DAMAGED CORD OR PLUG, If damaged, have replaced immediately by a qualified serviceman.
•Do not oPerate charger if it has received a sharp blow. been dropped, or otherwise damaged in any way,'take it to a qualified serviceman.
•Do not disassemble charger; take it to a qualified serviceman when service or repair is required.
Incorrect reasaembly may result in a Hskof electric shock or fire.
•To reduce dsk of electric shock, unplug charger from outlet before attempting any maintenance or
cleaning. Turning off Controlswillnot reduce this risk.
•Do not use charger outdoors.
•Disconnect charger from power supply when not in
_Jse.
•SAVE THESE INSTRUCTIONS. Refer to them frequently and use them to Instructothers who may use this tool. If you loan someone this tool, loan them these instructionsalso.
A, WARNING: Some dust created by power
sanding, sawing, grinding, drilling,and other constructionactivitiescontains chemicals knownto
cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are;
•lead from
•crystaltitesilicafrom bricksand cement and other masenw products, and
•arsenic and chromiumfrom chemically- treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designedto tilterout microscopic particles.
_k Look for this symbol to point out important safety precautions. It means attentionlll Your safety is involved.
WARNING:
The operation of any power tool can result in foreign objectsbeing thrown into your eyes, which can result in severe eye damage. Before beginning power tool operation, always wear safety goggles or safety glasses with side shields and a full face shield when needed.
We recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses with side shields,available at Sears Retail Stores.