10/03/01 WED 13:46 | FAX 884 084 3314 RYOBI CUST0_ER SERVICE | _010/015 |
SWITCH LOCK
See Figure 5..
The switch trigger can be locked In the OFF position. This feature can be used to prevent the poasibNityof accidental sta_lng when not in use. To lock switch
trigger, place the direction of rotation selector in center position.
CENTERPOSITION
(LOCK)
FORWARDREVERSE
SELECTOR
SWffCH
TRIGGER
Fig. 5
KEYLESS CHUCK
See Figure 6.
Yourdrillhas a keylasschuck.ASthe name implies,you can handtightenor release drillbitsin the chuckjaws. Grasp and holdthe collarof the chuckwith one hand.
Rotate the chuckbodywithyour otherhand. The arrows on the chuckindicatewhichdirectionto rotate the chuck.
bodyin orderto LOCK (tighten)or UNLOCK (release) the drillbit.
UNLOCK (RELEASE)
DRILLBIT
LOCK
A WARNING: Bs=eP/tools are always in operating condition. Therefore, switch should always be locked when not in use or carryingat your side.
REVERSIBLE
See Figure 5.
This tool has the feature of being reversible. The direction of rotationIs controlledby a selector located above the switch trigger. With the drill held In normal
operating position,the direction of rotation selector should be positionedto the left ot the switch for drilling.The drilling direction is reversed when the selector is to the right of the switch, When the selector Is In center position,the switch trigger is locked,
changing the direction of rotation or the two- speed gear train
To stop. release switch trigger and allow the chuck to come to a complete stop.
(TIGHTEN)CHUCK COLLAR
Fig, 6
not hold chuck body with one
AWARNING:handuseDOpower of the drill to tighten chuck jaws on drill bits.Chuck body could slip in your hand or your hand could slip and come In contact with rotatingdrill bit.This could cause an accident resultingin serious personalin}ury.