Know Your DRILL-DRIVER, Keyless Chuck, Switch

KNOW YOUR DRILL-DRIVER

See Figure 1.

Before attempting to use your drill-driver, familiarize yourself with all operating features and safety requirements.

_i WARNING: Carefully read through this entire owner's manual before using your new drill-driver. Pay close attention to the Rules For Safe Operation, Warnings and Cautions. If you use your drill-driver properly and

only for what it is intended, you will enjoy years of safe, reliable service.

_i WARNING: Do not allow familiarity with your drill- driver to make you careless. Remember that a care- less fraction of a second is sufficient to inflict severe

injury.

KEYLESS CHUCK

Your drill-driver has a keyless chuck that allows you to hand tighten or release drill bit in the chuck jaws.

SWITCH

To turn your drill-driver ON, depress the switch trigger.

Release switch trigger to turn your drill-driver OFF.

SWITCH LOCK

The switch trigger can be locked in the OFF position. This feature helps reduce the possibility of accidental starting when not in use.

VARIABLE SPEED

This tool has a variable speed switch that delivers higher speed with increased trigger pressure. Speed is controlled by the amount of switch trigger depression.

TWO SPEED GEAR TRAIN

Your drill-driver has a two speed gear train designed for drilling or driving at HI or LO speeds. A slide switch is located on top of your drill to select either HI or LO speed.

FORWARD/REVERSE SELECTOR

(DIRECTION OF ROTATION SELECTOR)

Your drill-driver has a forward/reverse selector located

above the switch trigger.

WRIST STRAP

A wrist strap is provided to reduce the chances of dropping your drill-driver. Place one hand through the wrist strap when carrying tool.

BIT STORAGE

When not in use, bits provided with your drill-driver can be placed in the storage area located on the top of the motor housing.

LEVEL

To keep drill bit level during drilling operations, a level is located on the top and end of the motor housing.

_i, WARNING: If any pads are missing, do not operate your drill-driver until the missing parts are replaced. Failure to do so could result in possible serious personal injury.

	PRODUCT	SPECIFICATIONS:
DRILL-DRIVER		315.271220
Chuck		3/8 in. Keyless
Motor		DC Motor 12 Volt
Gear Train		Two Speed
Switch		Variable Speed
No Load Speed		0°350 RPM (Low)
		0-1100 RPM (High)
Clutch		24 Positions
Maximum	Torque	350 in./Ibs.
CHARGER		ITEM NO. 9-11040
Input		120 V, 60 Hz, AC only
Charging	Voltage	9.6 - 24 Volt
Charge Rate		1 Hour
BATTERY	PACK	ITEM NO. 9-11031